Electronics Forum | Fri Jun 25 16:54:25 EDT 1999 | C.K.
| | | Dear John/Earl | | | | | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | | | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the
Electronics Forum | Fri May 29 16:07:55 EDT 1998 | Steve Gregory
| | Thanks Steve- | Here is the whole story: | | The solder balls are appearing all over, similar to a | splatter. They are relatively small. We are using H-Technologies | S-HQ no-clean solder paste. The stencil is 6 mil and the boards | are ru
Electronics Forum | Mon Jul 26 11:20:40 EDT 1999 | Kevin Hussey
| | | Which among the two profiling method is more reliable/accurate in getting the oven thermal profile? | | | | | | a) using a HIGH-TEMP solder wire then soldering the thermocouples onto the profile points of the board (e.g. component lead etc.) |
Electronics Forum | Thu Jul 29 11:58:06 EDT 1999 | Greg Jones
| | | | Which among the two profiling method is more reliable/accurate in getting the oven thermal profile? | | | | | | | | a) using a HIGH-TEMP solder wire then soldering the thermocouples onto the profile points of the board (e.g. component lead e
Electronics Forum | Tue Aug 10 16:57:29 EDT 1999 | JohnW
| | Does anyone use reflow profilers? Are they a good investement or is trial and error sufficient? | | | | Does anyone have any suggestions on profiles to try? Thanks. | | | Danielm | I would hazard a guess that most if not all of us production f
Electronics Forum | Sun Sep 28 17:14:53 EDT 2008 | ronsou
small pads like 0402 tend to get hot quite > easily. looks like excessive heat is your problem > here. pads are wetted, component leads are not. > this means solder paste flux on top layer was > exhausted before entering in reflow. your profile
Electronics Forum | Fri Feb 25 04:46:36 EST 2000 | Jeff Sanchez
Hey Travis, Thanks for the response. I did find a simple profile to use. As you said it took alot of trial and error. I was just looking for a good place to start. As for questioning the capability of a batch reflow oven,they have good reviews f
Electronics Forum | Tue Jul 11 15:59:52 EDT 2000 | JohnW
George, I looked at the winkic & profit software and tool's a while ago along with some of the alternatives. No matter what anyone tell's you in the 1st instance you do still need a profile card as what you are doing is comparing the known good prof
Electronics Forum | Fri Feb 25 04:46:36 EST 2000 | Jeff Sanchez
Hey Travis, Thanks for the response. I did find a simple profile to use. As you said it took alot of trial and error. I was just looking for a good place to start. As for questioning the capability of a batch reflow oven,they have good reviews f
Electronics Forum | Tue Dec 28 12:55:16 EST 1999 | Justin Medernach
Greg, The best advice that I can give you is a PBGA will respond just like any other surface mount package. There may be a 5 degree delta between a PBGA 356 and a QFP208 but the two respond very similarly in the convection reflow environment. CBGAs
winsouce.jpg)
.gif)
