Electronics Forum | Sat Dec 30 19:02:19 EST 2006 | mika
This type of component packages works best with vision type: 254 - irregular. Measure the total package length including the leads. Also set the body dimension x-y tolerances to at least 0.35mm and the the pick up x-y tolerences to 0.5mm in the part
Electronics Forum | Mon Jan 29 10:50:35 EST 2007 | mika
What about the component placement with Head #2? Head # 1 is ok? Is it only the pickup that is the problem and if so, from all feeder banks (front & Rear)? Concider Z-axis height adjustment, procedure is in the manual. You normally don't need to re-
Electronics Forum | Wed Mar 28 23:02:50 EDT 2007 | jmelson
If I couldn't afford to go to Boston to get some training from the seller, I certainly can't afford a week in Australia! But, thanks for the offer. I do have the HHK (hand held keypad, that's what Philips calls it.) And, after tinkering with var
Electronics Forum | Tue May 08 09:15:12 EDT 2007 | kenpeh
Hi It is very interest topic on building a AOI internal.(10000) I am very aggree on Machine designer point of view. I had gone throught the state of develop a post reflow AOI which complete it begining of this year. Just share part of it. Few poi
Electronics Forum | Wed Oct 17 09:19:23 EDT 2007 | actech
This box has the I/O card mounted sideways under it's own cover on the side of the main box. The CPU card is the bottom card. The Two driver cards X/Y and R/Z are side by side and mount to a steel base pannel with there relays at the back. but even i
Electronics Forum | Tue Jan 29 12:40:07 EST 2008 | somprakash
With the objective of providing highly learning experience with cost-effective RFID courses at your desktop, RFID4U � A World wide leader in RFID learning solutions offers spectrum of RFID e-Learning courses which split into separate series like Comp
Electronics Forum | Fri Apr 05 20:00:08 EDT 2013 | microaide
I cheated on the escapement length for the SOLIC plate and got through Feeder Optimization and Generate Program without any errors. Some progress, but no I cant figure out how to the the generated program into the central controllers on the Quad IVc
Electronics Forum | Fri Apr 12 19:20:25 EDT 2013 | microaide
Some progress, now stuck again. I can now generate a pick and place program for two heads that actually runs the head 1 program when loaded into the central controller of machine #1. But all attempts at getting machine #2 to run the head 2 program ha
Electronics Forum | Mon Oct 20 14:56:51 EDT 2014 | rgduval
Progress!! Somehow, this morning I was able to get things almost working. I swapped cards 1 and 2 back, and then back again, so, in the same state as my last reply...set the default settings for the axes configuration...then, verified the addresses
Electronics Forum | Wed Nov 15 14:33:57 EST 2017 | nc_dan
We acquired a used ViTrox V510 AOI machine, our first AOI machine. The programming interface is quite a bit different from our Pick and Place machines so our current tech is not familiar with it. We read the programming manual and made some progress
winsouce.jpg)
.gif)
