Electronics Forum | Tue Apr 23 02:43:41 EDT 2019 | bukas
hello everyone, my ERSA has some sort of RAM error, error messages and suspected IC in pictures. did any of you come across something like this and does anyone know where/how to get new IC/motherboard? Thank you.
Electronics Forum | Wed Apr 24 03:43:26 EDT 2019 | bukas
solved, machine boot did the trick.
Electronics Forum | Thu Apr 25 02:00:37 EDT 2019 | bukas
it seemed logical to me that there is only one master :)
Electronics Forum | Wed Apr 24 11:44:25 EDT 2019 | roblackey
Hi Bukas, Well done. BTW the part in the picture is a ROM. the RAM is IC6.
Electronics Forum | Mon Feb 06 19:56:07 EST 2006 | bobpan
Ok....that is very vague...but here is the approach i would take. 1. rename permanen.tbl file and reboot 2. rename calibrat.arc file and reboot * both files are located in c:\2kla\gui\guiqsv1* If it fixes the problem....it was a software issue. 3. If
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Wed Feb 23 13:22:31 EST 2022 | micropak
Congratulations on being operational again... Few years ago, I acquired a Siplace line (S20 + F3 + S15 + G2) and I rebuild it completely because the line was lying idle for more than 10 years. All belts, pneumatic cylinders, pneumatic pipes were cha
Electronics Forum | Sat Nov 27 08:30:06 EST 2021 | ravikumargv
We replaced RAM from 128MB to 266MB and after replacement Dr. Watson error gone and now we shucked with embedded time out error..
Electronics Forum | Mon Jan 20 19:09:53 EST 2014 | jgarver1
Did you replace the battery already? That is typically what causes the RAM error. E-mail me direct at jared.garver@ibesmt.com if the problem persists. Thanks, Jared Garver
Electronics Forum | Mon Nov 09 10:19:17 EST 2020 | gregdavill
I've picked up a Yamaha YM66S II machine, On powerup it displays the following: "ERROR CODE-RAM DATA!" "INSERT SYSTEM DISK" The machine looks in good condition, and I'm reasonably confident the RAM error is just a depleted primary battery on the co
.gif)
.gif)