Electronics Forum | Wed Jul 28 12:02:48 EDT 1999 | Wolfgang Busko
| | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That wou
Electronics Forum | Thu Jul 29 15:35:05 EDT 1999 | Earl Moon
| | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That wou
Electronics Forum | Thu Jul 15 14:55:24 EDT 1999 | JohnW
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Fri Jul 09 09:01:18 EDT 1999 | Marc P
| | Hi! | | I'm a process engineer attempting to do a capability study on our existing convection reflow oven - Heller 1500. It was recommended by an independent consultant to do at the very least, load testing, process ready testing, and board unif
Electronics Forum | Thu Jun 24 22:22:06 EDT 1999 | Dave F
Problems with downloading papers from the library not withstanding, downloading other papers in the library is problematic, as follows: Understanding SP440 Heating & Vacuum Functions Credit/ Source: LEO HUERTA, TECHNICAL SERVICES ENGINEER Works fi
Electronics Forum | Fri Jun 25 16:54:25 EDT 1999 | C.K.
| | | Dear John/Earl | | | | | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | | | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
Electronics Forum | Mon Jun 07 10:57:31 EDT 1999 | Dave F
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
Electronics Forum | Thu Jun 03 10:09:59 EDT 1999 | Earl Moon
| In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We cann
Electronics Forum | Thu Jun 03 10:53:09 EDT 1999 | Ryan Jennens
| | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We ca