Electronics Forum | Mon Aug 22 09:27:20 EDT 2005 | javi
The list is not yet completed but I picked few different component that our supplier are not able to get in Lead-Free or problem to get leadtime: Mfg Part : Zener Diodes BZG03 - MFG : Phillips Mfg Part : PME271Y447M - MFG: Evox-Rifa Mfg Part : LMC606
Electronics Forum | Mon Aug 22 10:01:17 EDT 2005 | rlackey
The list is not yet completed but I picked few > different component that our supplier are not > able to get in Lead-Free or problem to get > leadtime: Mfg Part : Zener Diodes BZG03 - MFG : > Phillips Mfg Part : PME271Y447M - MFG: > Evox-Rifa Mf
Electronics Forum | Sat Oct 21 07:50:15 EDT 2000 | Adam
A question for all you wavesoldering buffs out there ? What i'd like to know is what causes the bulb-shape type joints around chip components when flowed over the wave ? which wavesoldering process parameter contributes to this type of defect & how
Electronics Forum | Fri Dec 27 01:26:08 EST 2002 | haran
Currently we are running a BGA with a big thermal pad in the middle of the package and encountered high defect of solder shorts.I would like to check whether anyone has experience this problem and how this can be rectified?.
Electronics Forum | Fri Dec 27 01:30:13 EST 2002 | haran
Currently we are running a BGA with a big thermal pad in the middle of the package and encountered high defect of solder shorts.I would like to check whether anyone has experience this problem and how this can be rectified?.
Electronics Forum | Mon Jun 28 09:15:21 EDT 2004 | jdumont
Morning all, we have been seeing some problems with the edges of some of our BGA's curling away from the PCB after reflow. Is this possibly a moisture problem? If so what would be a good time/temp to bake them at to rectify the problem? Thanks in
Electronics Forum | Fri Nov 02 05:50:06 EDT 2007 | meritajs
Dear Jon You are right Our dump bucket location was without reach 3 head. We rectified this position and now mounter works OK Thank you Peter
Electronics Forum | Fri Apr 15 18:41:35 EDT 2011 | swarnergictg
We had a similar problem with contaminated leads that was rectified by having a company strip the existing finish and re-tin the leads. After the procedure the leads accepted solder with no issues.
Electronics Forum | Fri Aug 25 04:43:58 EDT 2017 | praveenmuthusamy
Thank you so much for your valuable feedback . Root cause was found that amount of solder paste printed on board is uneven. Uneven solder paste printing was Due to misalign of backup support pins in PRINTER. Problem was rectified after changing backu
Electronics Forum | Thu Aug 01 13:15:52 EDT 2019 | davef
if the inductors were your only problem. My mom wouldn't be pleased with the V30200C dual voltage rectifier just below the inductors
