Electronics Forum | Tue Aug 13 10:35:16 EDT 2019 | sankarseptember
In Siplace mounter if i remove feeder with component from feeder pallet in machine..and again i set feeder in same location machine does not to verify and indication become green.Is there any option for setup verification any feeder removed even for
Electronics Forum | Tue Jan 21 16:11:05 EST 2020 | dgiordano
3.3.5.1 HIC Placement states "The HIC may be placed anywhere in the MBB, but should not be placed under, on top or touching a desiccant pouch." How do you assure that the HIC doesn't touch the desiccant pouch? Do you secure the HIC to the reel or to
Electronics Forum | Thu Jun 25 11:30:18 EDT 2020 | kylehunter
I'd love to see a thread focused on various methodologies used for general inventory management schemes, but primarily on procedures to ensure the proper parts get loaded on the pick and place. We have an Assembleon pick and place, so there is no fe
Electronics Forum | Thu Dec 10 12:12:40 EST 2020 | robl
Yep, done it previously with a multipot machine. Using with wirefeed to top up the pots means you only have a contamintion risk when you fit a new top up reel. Used separate nozzles for both, but theoretically using titanium nozzles would mean no c
Electronics Forum | Mon May 24 16:08:43 EDT 2021 | robl
Can you have the SMT lines or feeder carts as "stock locations" on your system and issue them to that location? then at least when you go to your pick list you'll know where it is. That's assuming you can do this quickly.
Electronics Forum | Mon May 24 17:01:22 EDT 2021 | emeto
The good solution is to adopt ERP system and barcode tracking for everything you have in inventory. If not, SMT supervisor will keep super complicated excel sheets to track what is where..... Or.. you can request all to be kitted together and confirm
Electronics Forum | Mon Oct 18 14:31:01 EDT 2021 | charliedci
We recently purchased a Scienscope AXC-800 III which can count 4 7" reels at one time in seconds. It can count tubes, trays and bulk as long as keep the components down to 1 layer (which for bulk is not ideal). so far we are very happy with, cuts dai
Electronics Forum | Mon Jan 10 03:48:15 EST 2022 | proy
Has anyone here got any innovated neat fast ways to quickly cut the end of an IC tube open clean and fast so that parts feed properly from a tube on a vibe (as best they can...) AND or any low volume easy to setup automated tube to tape and reel setu
Electronics Forum | Fri Jun 10 19:22:59 EDT 2022 | jdengler
Yes. We only do the side not under the component and do 25 mils if there is enough room. A solder preform is simply a block of solder that is shaped like a SMT component and comes in tape and reel. Most solder manufactures offer these. You can ta
Electronics Forum | Tue Jun 21 14:56:56 EDT 2022 | davef
With conductive elements, we reduce static build-up by connecting the item to the ground through a wrist strap, mat, or similar methods. With non-conducting items like paper or plastic, ionizers are used to reduce static build-up. For more on ionize