Electronics Forum | Thu Mar 24 07:06:06 EST 2005 | davef
There's a lot of comparison tables on the web. Here's one: Properties - Summary [A Winlow Circatex] Attribute||Hasl||Immersion Silver||Immersion Tin||Electroless Pd||OSP||Eless Ni / Imm Au Shelf Life (months)||12||12||12||12||12||6 Multiple Reflows
Electronics Forum | Fri Feb 17 09:35:00 EST 2006 | Rob
Hi, I take it you are refering to intrusive reflow? It came around as more components became available in surface mount packages leaving mainly connectors left over for a separate insertion operation & wave/selective/hand solder. Manufacturers imp
Electronics Forum | Tue Mar 07 10:46:24 EST 2006 | muse95
I have to disagree with you, BillyD. If Craig searches the forum, he will see that the concept of a Pbfree BGA with SnPb paste has been debated many times. You say it is fine. I say it is NOT. There have been several studies done that clearly sho
Electronics Forum | Mon Mar 05 16:16:08 EST 2007 | Mark
Hello, We are having issue with one of the customer board. This is 10 layer PCB FR4 with black solder mask. Coating Ni/Au. Soldering leadfree. We are using 7 zones air reflow oven (zones top&bottom). We have bed solder flowing for this boards. T
Electronics Forum | Mon Jul 16 10:51:09 EDT 2007 | patrickbruneel
D. Hillman, et al., �The Impact of Reflowing a Pb free Solder Alloy Using a Tin/Lead Solder Alloy Reflow Profile on Solder Joint Integrity,� International Conference on Lead-free Soldering, CMAP, Toronto, Ontario, Canada, May 24-26, 2005, http://www.
Electronics Forum | Wed Jan 23 19:44:45 EST 2008 | hegemon
In addition to the pre-emptive steps mentioned above, in my experience there are certain BGA package designs that seem more prone to that corner bridging. I have seen some packages that will essentially "curl" down at one corner as the package begin
Electronics Forum | Wed Sep 07 00:47:53 EDT 2011 | woodsmt
PCB, What is telling you that you have cold solder? You do not give much info. My QA/QC love this term to describe a multiple of issues. They are usally very wrong. If this is a reflow process and it just affects one part? An SSOP is not likley t
Electronics Forum | Fri Feb 01 19:07:57 EST 2013 | hegemon
We have had some success in void reduction with LGA by pre-tinning or "bumping" the devices before placement. The extra solder seems to allow a slightly higher standoff, and allows better outgassing, is my guess. A lot more labor , but the results
Electronics Forum | Mon Aug 14 14:27:00 EDT 2017 | emeto
Here is some food for thought. Try to answer these questions yourself and I am sure you will see huge improvement. Reasons: - Bad PCB design - Plating-uneven HASL cause more than OSP Au/Ni or Silver - Poor paste and print quality - uneven paste ca
Electronics Forum | Tue May 28 18:31:08 EDT 2019 | jlawson
Solder paste flux is main contributor, Lead termination chemical-oxide by products and PCB Plating-Chemicals. Reflow profile would have very limited if not no impact really unless is way off. Paste volume control and Stencil design plays a big part
winsouce.jpg)
