Electronics Forum | Tue May 02 16:33:18 EDT 2000 | Joe
hi, I am looking for some guidelines which can tell me when gullwing and finepitch leads are too damamged to repair. Copper gets hard when bent and the electrical resistance increases. When a finepitch component gets dropped a lot of pins need staig
Electronics Forum | Fri Mar 02 11:13:50 EST 2001 | fkurisu
Hello Mark, To date all solder mask rework we have done has been on the PCB board. I believe that it possible to reapply solder mask on to the ball side of the BGA. Would it possible to evaluate some of your BGA's? You can contact me at 714 842
Electronics Forum | Mon Mar 12 18:14:44 EST 2001 | reconsales
We stock over 3000 used Panasert feeders and have many parts in stock. We can also repair / calibrate your feeders with our PFA factory alignment fixture. Please provide us with an accurate description of the parts you need. Give an accurate descri
Electronics Forum | Mon Mar 19 08:26:37 EST 2001 | hany_khoga
Dear All: We have a problem of soldering big BGA's (3.5Cm * 3.5 Cm)during rework or repair. With three big companies stations (hot air & infrared) with their support, they faild to re-solder even one BGA succesfully. Note that we workes on a good te
Electronics Forum | Thu Apr 05 13:08:03 EDT 2001 | Garth Fitzner
I have around eight Quad 100 feeders that are giving me some problems. I think they probably just need a good cleaning and perhaps some minor repairs. Quad Technical Support can't help me and suggested I post a message here. Is there anybody who co
Electronics Forum | Thu May 31 15:04:49 EDT 2001 | flipchip
Check out APE's web site. http://www.apecorp.com There is also a repair video at http://members.nbci.com/smtrework/chipmaster.ram showing cans being removed. If you have any questions or want to see a demo in house, give us a call. 305-451-4722
Electronics Forum | Thu May 31 15:05:07 EDT 2001 | flipchip
Check out APE's web site. http://www.apecorp.com There is also a repair video at http://members.nbci.com/smtrework/chipmaster.ram showing cans being removed. If you have any questions or want to see a demo in house, give us a call. 305-451-4722
Electronics Forum | Thu Aug 02 19:48:53 EDT 2001 | davef
IPC-7711 & IPC-7721 Training and Certification Program Detailed information on the industry standard program for rework, repair and modification of electronic assemblies. [http://www.ipc.org/html/fstraining.htm] Guides and training at http://www.cir
Electronics Forum | Sat Feb 05 12:36:09 EST 2000 | Albert Hay
Hello everyone, I am cosidering the possibility of using Low-Melt solder for repair purposes. However, I am concerned about adding a new alloy (agent) to the board that already has the No-Clean solder on it. Also, is the Bismuth in the Low-Melt comat
Electronics Forum | Thu Feb 03 16:51:54 EST 2000 | Doug Philbrick
I have used a PDR I.R. machine for BGA repair and I personally liked it. The two big features I liked were no special tooling and it has a IR temp probe that is closed loop and will keep the temp where you programmed it. The vision allignment works w
