Electronics Forum | Mon Dec 10 01:55:54 EST 2007 | Frank
Here are some questions you should be considering... How many of each machine type are actually installed and being used in the market? What is the local support in your area from each vendor? Where are their spare parts warehoused? What is the w
Electronics Forum | Tue Feb 12 16:24:21 EST 2013 | larrygroves
Dave, It depends on what you mean by swapping heads. If you want to move the aligners its not too hard. If you want to move the entire head assy it will require a lot of calibration. Anything can be done but it really about the cost and the value
Electronics Forum | Mon Sep 16 13:21:19 EDT 2013 | larrygroves
yes, in old age Z motors do fail on the machine. also, the spring I am talking about is in the rack assembly. there is a split gear which engages the motor gear and it has a spring which maintains constant engagement with the gear. it is small and
Electronics Forum | Thu Sep 04 09:05:00 EDT 2014 | JB
Hello All. Another question about programming if anyone could help? We are current placing BGA's and it places them fine but we have noticed it doesn't spot when a ball is missing. We have adjusted the settings so it does reliably spot the missing
Electronics Forum | Tue May 20 04:34:59 EDT 2014 | sarason
Well that would be a response from the VME bus. Is the PCBoard, the only controller on the buss, or is there a second controller that talks to interface boards etc. If so you might just have a problem with the second controller. Check the control sig
Electronics Forum | Wed May 21 15:13:56 EDT 2014 | wendynguyen234
Sarason, thank you very much for your support. There is an ISA interface board with just ribbon cable from window 95 PC to VME I/O DPRAM ver. 2 board in the same VME rack that has MVME-162-110 (CPU board), DSP, ADDA, AXIS & CONT boards. Do you think
Electronics Forum | Sun Nov 06 03:09:44 EST 2016 | muzzy
Hello. Thank you for your answer. Yes, you are right. It would be best to badmark those boards. But we, as a small contract assembler, can't throw away a 1/5 of client boards just because of damaged fiducials. Using pads and other features as fiducia
Electronics Forum | Fri Apr 13 02:35:42 EDT 2018 | kimseo
PROBLEM SOLVED I bought a diagnostic PC card (ISA/PCI) for checking the PC of the machine... Firstly I tried ISA slot - nothing happend.. the diagnostic card didn't work... so I tried to put it into PCI slot but.... what happend ? The machine starte
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Wed Aug 07 01:44:52 EDT 2019 | orbitcoms
I have several reels of components I purchased from Chinese source. During pick and place, the tapes keep breaking (they tear diagonally along the reel). I notice the tape is very tight if I try to pull through manually. I tried several over 12mm fe
