Electronics Forum | Mon Nov 13 04:30:16 EST 2006 | Loco
:o You wouldnt happen to have shares at BTU, Fastek? What you are replying is just what Kris was talking about. I wouldnt take it either. Customer service should be very important for any company. Imagine a broken oven, company coming to a stand
Electronics Forum | Thu Nov 16 10:51:08 EST 2006 | dman97
Does anyone know if it is possible to upgrade the sigmapro software on these machines to a newer version? We are running version 6.35.19 and it just really sucks. Is it possible to go up to say version 7 without upgrading any hardware on the machine?
Electronics Forum | Tue Nov 21 11:59:43 EST 2006 | billwestiet
These machines are very different. It falls under "there are no two machines alike" category. When you say the same profile, do you mean the same setpoints, or the same actual board profile that you get from running a profiler with TC's on the boar
Electronics Forum | Tue Nov 28 10:26:46 EST 2006 | russ
interesting Bill, will keep an eye out. Was not necessarily saying anything about Chinese product, just the engineering, I have seen a few Chinese "Vitronics" ovens and yes they seemed to be put together very well, I was only mentioning how it/the
Electronics Forum | Thu Dec 07 20:28:07 EST 2006 | davef
When rushing to get a job done, it's easy to accidently remove solder mask from a nearby via when dressing BGA pads after removing the part. Just hit the via with some super glue [then say a small prayer] and push on. As an alternative, look here:
Electronics Forum | Mon Dec 11 17:19:12 EST 2006 | darby
Hi AJ, Thanks for the reply. I'm beginning to think that we have some issues with different expansion rates of the two pcbs. When you say you had some profile issues... Did you stay within the recommended UBLOX reflow time of 20 - 40 seconds and di
Electronics Forum | Thu Dec 14 21:17:47 EST 2006 | Thomas
Hi,I apologize for my poor english. I am just wondering why this excellent site did not came out with any information about the server exchange, I asume that was the deal, because that was the info recievied back when one tried to logon? Anyhow, why
Electronics Forum | Fri Dec 15 11:06:06 EST 2006 | Gman
Hello All, Is Ionic Cleanliness testing using say an Ionograph on No-clean assemblies a valid test? If not, why? I understand factors like PCB cleanliness but is the 1.56ug/in2 IPC criteria valid for no-clean assemblies and can an Ionograph be used
Electronics Forum | Sat Dec 16 21:41:19 EST 2006 | bvdb
I'm at home right now but remember that the MCS-16F boots up saying V2.3. The IP-1 is a 1986 machine but the MCS-16F was purchased used as a replacement to one that didn't work. The vintage is unknown. Tomorrow is Monay and I'll see if there is an
Electronics Forum | Thu Jan 04 04:49:51 EST 2007 | geb
Thanks, Chunks. Your first post was correct, it turned out to be the battery. That is that problem solved. Unfortunately I have now got an error message saying Flux Management Failure. Is this just a coincidence? It sounds like something to do with t