Electronics Forum | Wed Jun 23 10:26:53 EDT 2004 | exmaintenanceleader
Grant and all! CP-2 is the oldest fuji as I have been operated. CP-3 is built in 1989 as a new mc. Now 15 mc I now they runs in 3 shift widouth problems when they need countinous runing comes the problems. conroll card and relay contact problems at
Electronics Forum | Fri Oct 15 03:00:21 EDT 2004 | pierrenoir
Hello to you all I was hoping one of you guys would be good enough to give me some advice on a problem I am having with some training simulators I have developed for my work. I have basically built two electronic control simulators to duplicate the o
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
Electronics Forum | Wed Jan 18 21:30:38 EST 2006 | daxman
Hello everyone! I'm new to this forum. I just got back into an SMT career after a 4 year break, and it feels good to be back. Anyways, I'm doing some maintenance work with a Fuji CP-645. It has a few problems that I am currently unable to isolate, a
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Tue Mar 28 19:17:17 EST 2006 | daxman
Hi guys, Sorry I haven't posted in awhile...but here are the details.. The noise in the cam box is the C-axis coupling. (Sr.Tech was right) Applying a little oil to the coupling pins killed the noise, but cam back in a few hours. We are in the proce
Electronics Forum | Thu Oct 11 18:06:45 EDT 2007 | jmelson
Ohh, MY! Well, there is a whole block of info that is machine specific. There are 4 things on the main menu, the last one is the system calibrations. It has offsets between the primary reference (if you don't have vision, like mine) then the beam
Electronics Forum | Sat Feb 27 00:59:43 EST 2010 | jmelson
Hi, I have a CSM84, PA1306/20. When I got it, a lot of the offsets had been zeroed out. I figured out a procedure to calibrate the back feeder rail, but haven't come up with a scheme to calibrate the mechanical alignment unit. I have it close, but
Electronics Forum | Tue Oct 05 16:38:51 EDT 2010 | tskim83
Our hole inspector gives this error message “Base Hole Error”. It is a flat conveyor-type hole inspection machine from YAYATech that scans PCBs, with an optic sensor and cameras on top of the belt and a light source on the bottom of the belt. And dur
Electronics Forum | Wed Mar 21 06:01:07 EDT 2012 | hunzo
Hello Sergey, I have used Kirsten Modula Wave with ADL (anti dross liquid) option. We have had the same expectation like you: less dross and lower operation cost due to no inert gas is required. That is achieved, the dross generation was modest and t
winsouce.jpg)