Electronics Forum | Thu Dec 18 13:07:50 EST 2014 | kevinb
I have worked with Epoxy Technology in the past with silver epoxy. Just to fill you in on what I have been doing with this project in the past. I was using a silver epoxy for my 0201s. I then over molded with an epoxy with a dam and fill. Then th
Electronics Forum | Mon Mar 09 12:52:38 EDT 2015 | brianbrl
Hi, I had Assembleon machines for many years, and worked through a total of nine of them. Three years ago we began to look at the short-comings we had, based on the machines capabilities. We started to look for a new SMT platform that could improve
Electronics Forum | Thu Jul 30 16:38:40 EDT 2015 | lokit
There are several big competitors out in the field. Since a few years 3D AOI is getting more and more populair. The reliability is much higher compared to comparing grey scales (pixels) with one another. Measuring the height, length and width of a co
Electronics Forum | Fri Jan 22 11:04:38 EST 2016 | stevea
The answer is CyberOptics. Buy Viscom SPI and you are already buying "CyberOptics Inside". Koh Young is far too expensive these days for comparable systems and Parmi is still an "Up and Comer" with a short track history leaving most of the long ter
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Sat Jul 16 17:29:50 EDT 2016 | aemery
Yes, you need to run the 'offsets' calibration to correct the offset issue. If the machine is in good working order and all of the other alignments and cal's are completed then you are good shape to go to run this cal. If not, you could waste a few
Electronics Forum | Wed Jul 20 12:48:21 EDT 2016 | adamjs
Hi, is there a reason why washing "no-clean" flux residue off of boards with 1(or 2)-ethoxy-propanol is not a widespread practice? This chemical is more commonly known as Henkel/Loctite/Multicore SC01. I've long known, as I'm sure most people do, t
Electronics Forum | Fri Aug 05 23:52:34 EDT 2016 | lilybell
I'm making some PCB's that have some DC to DC converters on them with three 5 Volt converters, one 15 volt converter, and a converter with +/- 12 volts DC. On the PCB the output pins are in a connector that are fairly close to each other. I want to m
Electronics Forum | Fri Sep 01 15:52:03 EDT 2017 | wyluliwolf
Long story short: I paid someone to convert some older Gerber files to the new RS-274x format for me so I could have them manufactured. I sent them the original Gerber files (RS-274D) along with additional files showing information on the layout. T
Electronics Forum | Mon Sep 18 05:46:07 EDT 2017 | spoiltforchoice
As Evitomov says, provided you check everything is setup correctly there should be no issue. There can be some variation between manufacturers as to how they package certain components. For example 2512 resistors are usually in 12mm tape with a 4mm s