Electronics Forum | Mon May 14 09:35:21 EDT 2018 | directx995
Hello everyone, A few days ago I design one special kind of PCB for testing accuracy of our Pick and Place machines. (for trimming, calibrating, NPI etc.) I am looking for adhesive spray, to apply it on PCB (at the moment I'm using double sided tape
Electronics Forum | Thu Aug 09 09:14:22 EDT 2018 | ks0707
Is there any special machines/equipment which are able to install FBGA parts on the very thin flex boards for Printing, Pick & Place, and Reflow ? Q2> Is there any Fixture house who can offer fixtures to enable SMT processes for those assemblies ? Q
Electronics Forum | Thu Aug 09 16:51:39 EDT 2018 | tey422
A good set of fixtures are what you need to get it done right. Since we are in the same area, I would recommend give ATD (Advance Tooling Design)a try, they located in San Jose. We been using fixtures from them for years. We build thousands of Fle
Electronics Forum | Wed Sep 12 09:47:29 EDT 2018 | junkeymonkey246
Hello everyone, I have 3 Contact Systems CS-400B's 2 of which need arepair and the last needs servicing and 2 CS-400E's which need repair. These machines have been sitting idle for years are are in need of repair. I was in touch with the manufact
Electronics Forum | Fri Sep 28 01:47:46 EDT 2018 | netvicher123
The followings may be the factors from your description: 1. chain speed and motor speed? 2. is the tin content even? (more or less on one side, or thickness of steel mesh, size of opening) 3. Is there any exception in the pin? 4. is there any level
Electronics Forum | Fri Oct 12 12:12:13 EDT 2018 | davidsmullins
We have some fairly standard 0.1" pitch, two row, shrouded, through hole headers soldered onto a thick backplane. There are tiny inspection holes along the bottom edge of the plastic body that allow an inspector to observe the top of the through hole
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Tue Dec 04 02:32:38 EST 2018 | ameenullakhan
Hi, Thanks for the valuable feedback. Agree with you. 1. We have similar component on both the side of the board. 2. The component fall was random like 4 out of 100 components.But last build it has increased. 3. Applying glue dot is option , bu
Electronics Forum | Tue Feb 05 13:14:27 EST 2019 | youngbuck
Hi Steve, Have you took the star completely off the Gantry. There are the 12 hoses to the star if Segment 1 connection hose is messed up everything will be off because everything gets measure off of Seg.1. Also, you could start eleiminating the probl