Electronics Forum | Mon Jun 21 16:36:54 EDT 1999 | John Thorup
| | | Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of ass
Electronics Forum | Mon Jun 21 14:51:37 EDT 1999 | JohnW
| | Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of assem
Electronics Forum | Sat Dec 04 09:23:20 EST 1999 | Christopher Lampron
Kantesh, Does this particular part have a heat sink across the bottom side of the component and does your pad size and stencil aperture match the component? I have just had a very similar problem with a DPAK. What we found was that the recomended pad
Electronics Forum | Sun Aug 02 20:31:22 EDT 1998 | karlin
Hi Bob, The weight of the TBGA is heavier then PBGA due to the Stainless steel heat sink. I have tried run them through the oven without paste. Due to the high lead content( 90Pb/Sn10), the "solder: did not melt. Still see the misalignment issue but
Electronics Forum | Fri Jun 06 16:11:25 EDT 2003 | RF Lurker
I understand that there may not be a lot of material on this, as most threads I've seen discourage doing it. It goes against DFM to do it. But I wish to use a large copper area instead of heat sink and thermal epoxy to cool a regulator. But I can'
Electronics Forum | Thu Nov 06 07:54:50 EST 2003 | davef
First, skewing is a perfectly acceptable condition, providing the amount of skewing is not excessive. A-610 provides guidance. Second, this part is a land grid device. Land grid devices [ie, BCC�, LGA, QFN, MicroLeadFrame�, etc] are essentially BGA
Electronics Forum | Mon Oct 18 22:15:11 EDT 2004 | KEN
I have two industry leading customers that have specific requirements for components to survive 30 seconds above 230C. In one case I have a custom ASIC that is heat sinked on the die (to the PCB). The sink pulls heat out of the lead frame very effi
Electronics Forum | Thu Dec 21 02:27:57 EST 2006 | pavel_murtishev
Good morning, (1) This depends on component type. In general it would be better to have fully populated board. Or at least you should mount components with different thermal mass. You should place TC�s at three points at least: component with high t
Electronics Forum | Wed Apr 18 09:16:51 EDT 2007 | Cecil
We currently have an assembly that we have to mask the surface of several (24)SMT components where thermal compound is applied at a latter operation. These component packages vary from BGA's to QFP's. After the thermal compound is applied the PWA is
Electronics Forum | Wed Jul 12 08:49:38 EDT 2017 | williamaxler
I have a few LED pcb's that have an aluminum > substrate that are ridiculous to rework. They > heat-sink like crazy and I can't reflow the bad > LED's, no matter how much heat I apply. Any > suggestions on techniques or equipment to use? > I ha
