Electronics Forum | Fri Jun 08 13:49:11 EDT 2007 | ck_the_flip
From my past experience, you can usually get away with OUT the chip wave if your SMD's are no smaller that 0805, and more importantly, there are no SOT23's. A nice, clean, inerted laminar wave (with a little smart or omega help) will solder your S
Electronics Forum | Fri Oct 17 20:26:21 EDT 2008 | diesel_1t
If is IP-1, is using SMD2 vision instead of SMD3 (CPIV-IP3, CP6,7, etc) if so, you must use Vision Number instead of Vision type... if you're using fuji flexa just press F1 on vision number and you will se most common vision numbers depending on shap
Electronics Forum | Tue Jun 02 21:27:22 EDT 2009 | davef
We've never heard of a situtation where oversized pads caused voiding. Your supplier is correct that the pads on the board should be the same size as the pads on the interposer, but this is to improve reliability issues. Search the fine SMTnet Archi
Electronics Forum | Thu Jun 25 22:00:54 EDT 2009 | hayee
Hi, I want to make a small setup for manufacturing PCB's based on SMD's for (pototyping boards, etc). I don't know clearly what are the equipments required for this purpose. I have an idea that we have to use (Pick n place station, Screen printing
Electronics Forum | Mon Sep 13 07:14:34 EDT 2010 | mun4o
Hi all, we have two smd line, with 2 topaz X each.Software for optimizing is PPS v.8.0.The problem is that when PPS optimazing the programme, IC, diodes and other polarity components are with wrong orientation.But, I see the orientation onli when str
Electronics Forum | Mon Nov 15 02:45:15 EST 2010 | 89jeong
Hello. We encountered a SMD problem on PCB. It is that the lead of photocoupler is shifted after reflow and don't meet the minimum requirement of side joint length. I know this is a defect but what i want to hear the reason and the solution to prev
Electronics Forum | Fri Sep 15 04:09:15 EDT 2017 | philc
Yageo announced their decision to stop marking SMD resistors back in 2013, and since then we have started to see 0603's that aren't marked, but larger sizes - so far - are still showing a value. 0402's have never been marked, and I doubt they ever w
Electronics Forum | Tue Jun 18 23:24:05 EDT 2019 | SMTA-David
Hi, I have a SMD radio module that has castellated Pads along one edge of the module. The pick and place machine appears to place them very well but when the boards come out of the reflow oven then up to 20% of them have either rotated a few degrees
Electronics Forum | Thu Oct 31 13:46:40 EDT 2019 | johnce
Hello, I have searched the forums for this specific topic, but can not find the clarification I would like. I am setting up a baking system to "reset" SMD components using a vacuum-bake oven. According to the JEDEC-STD-033 standard, depending on th
Electronics Forum | Wed Feb 16 09:30:11 EST 2000 | MARK ALDER
Please refer to the archives on SMTNET date 02/19/1999 on aperture sizes for printing SMD adhesives. Regards Mark Alder