Electronics Forum | Tue Jan 25 13:06:47 EST 2000 | Bill Schreiber
When switching from cleaning RMA to a no-clean flux, one area that is commonly overlooked is the stencil cleaning operation. Stencil cleaners that are effective in cleaning RMA often fail when cleaning no-clean (especially alcohol cleaners). Pallet
Electronics Forum | Fri Jun 09 11:55:34 EDT 2006 | jbrower
Howdy Amol, As far as I can see, there aren't too many pitfalls with SN100C. Just make sure to keep all of your alloys seperated. The issues that I am working out right now is the profiles with our wave pallets and some of our larger components. We
Electronics Forum | Wed Feb 15 13:44:34 EST 2006 | samir
Bingo! In my career, I've used Wave Solder optimizer and the WaveRIDER. Pro's and Con's to both. I did a GR&R on both as well, and WaveRIDER came out on top. The main challenge is to get the operators to use it. I've found that the operators wer
Electronics Forum | Fri Feb 22 13:19:54 EST 2013 | caurbach
Our new Soltec Delta 3 has this feature (they call it mainwave pushup) where you can add up to 60 rpm to the pump after the leading edge passes over the wave. Unfortunately, our old Delta Wave doesn't have this feature. Ideally we'd like to set it
Electronics Forum | Mon Jul 10 09:25:47 EDT 2006 | nodlac
Here is a nugget from the Data Sheet... Wave Soldering: Excess moisture on the PCB during soldering may lead to random solder balling and poor wetting of some solder joints. IT IS IMPORTANT that the flux solvent carrier (water) is fully evaporated a
Electronics Forum | Wed Dec 24 15:28:17 EST 2008 | edmentzer
We use SN100C for wave soldering and hand Lead free soldering and have had very good results. The wire cored solder for hand soldering flows good and makes very good solder joints. The SN100C in the wave solder machine also works very good. We use
Electronics Forum | Fri Apr 06 08:32:47 EDT 2007 | davef
Haris: On your soldering issues, we don't know the make-up of your component. We don't know the type solder balls on the component. We don't know the solder paste you plan to use. Your component and paste supplier are better sources for this type o
Electronics Forum | Wed Dec 09 18:51:06 EST 2020 | johndep7
My company has been having issues with a lot of solder balls, solder splash, and flux balls all over a specific board. Now this is one of the only companies that require us not to clean our boards after our work is finished but this is also causing a
Electronics Forum | Wed Jul 05 09:00:13 EDT 2006 | russ
Sounds like possibly too little preheat. Russ
Electronics Forum | Thu Apr 05 05:05:09 EDT 2007 | Haris
Still confused what you are trying to say? And I didnt get the answer regarding soldering profile.
.gif)
winsouce.jpg)