Electronics Forum | Wed Aug 23 17:22:39 EDT 2023 | markhoch
I'm curious what you use for PCB Support. Are you using a dedicated support plate or are you using magnetic pins or some type of Grid-Lock system?
Electronics Forum | Wed Aug 23 17:43:42 EDT 2023 | calebcsmt
Support bars, so essentially the board is sitting ontop of beams that make a table. Fully supported with no soft spots
Electronics Forum | Mon May 20 13:14:05 EDT 2024 | dontfeedphils
I almost always go with an overprint as long as it's feasible. I haven't had much problem with solder-balling when overprinting. I'd give it a try and see how it works for you.
Electronics Forum | Tue Jun 04 17:05:52 EDT 2002 | davef
Solder balls floating around on the air currents of a reflow oven. I sincerely doubt it. Could the solder on your gold fingers be from: * Excess placement force during P&P? * Ejactula from solder deposits during rapid preheat ramp rates? * Ejactula
Electronics Forum | Thu Jun 29 06:26:36 EDT 2006 | AR
Hi Slaine, The terminations are still present on the component but all the solder (including the pad finish) has coalesced on to the terminations. The termination that normally is shiny and bright in colour has turned matte grey on that zone where t
Electronics Forum | Tue Dec 11 11:59:00 EST 2012 | sarason
The issue is surface tension around the connector. Your tip needs to have more surface tension than the pins of the connector as it forms a cluster when being soldered. When I used to solder superfine connectors with a metcal iron it had a horses hoa
Electronics Forum | Thu May 14 05:20:31 EDT 2015 | kielbik
Hi Im looking for a person who have a experience with Intel® Core™ i3-5157U (i5) Processor soldering (CL8064701478404). I want to compare our experience because i'm not sure about aur spare parts and our soldering way. They are original or not, becau
Electronics Forum | Wed Jun 21 08:53:25 EDT 2006 | stepheniii
Are you worried the terminations might b oxidized? Do a dip test. If you have a solder pot carefully dip one termination of the cap into the solder. And see how well it wets. If that test doesn't satify the powers that be, then you can design a more
Electronics Forum | Fri Feb 15 06:59:07 EST 2013 | davef
Use a standard that everyone will recognize. If you say, "The solderability test was performed in accordance with ANSI/J-STD-002 'Solderabiility Tests for Component Leads, Terminations, Lugs, Terminals and Wires'” [ipc.org/TOC/J-STD-002C.pdf ], every
Electronics Forum | Tue Dec 15 15:21:17 EST 2015 | davef
Peculiar that ENIG boards are corroded, not that it can't happen. * J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals and Wires * J-STD-003, Solderability Tests for Printed Boards The first person I'd talk with is my