Electronics Forum | Tue Nov 19 21:38:39 EST 2019 | zack
Hello, The first thing that you need to do is to make process mapping about this incident, so you can exactly determine all factors and observable changes happened during 2 weeks of timeline difference. According to my experience, if all equipment
Electronics Forum | Mon Dec 30 23:37:47 EST 2019 | agoesfirmanto
Hello All, I am a SMT Engineer from Indonesia, I am facing the problem of soldering balls in only one IC location, in other areas there are none. solder ball defect almost 30%. I have done several actions but failed to reduce the solder ball. 1.
Electronics Forum | Mon Apr 02 17:25:53 EDT 2012 | tombstonesmt
Just PM'd our Pillarhouse Jade Mark II this morning and found excessive solder balls all over the solder pot as well as the bottom of the machine. While removing all the dross it's very obvious that the dross is a REAL fine powder unlike any of the o
Electronics Forum | Thu Oct 23 23:38:48 EDT 2008 | pathakvj
We have 8 layer HASL PCB. We saw molten solder blobs / balls on op side of assembled PCB. (to check, if this was a bare board problem), We passed bare board as received thru, SMT reflow oven and saw solder balls on top side of board. What could be th
Electronics Forum | Mon Oct 01 16:55:27 EDT 2001 | davef
I agree. Poor soldering technique is the most straightward way of creating solder balls during hand soldering operations.
Electronics Forum | Thu Aug 05 02:05:09 EDT 2004 | Rafal M.
Balls are on the wave side.
Electronics Forum | Tue Apr 04 10:08:33 EDT 2000 | Russ
Neil, IPC 610 has the criteria for solder balls re. quantity and size per sq./in. These are acheivable requirements but no-clean is not necessarily a drop in process. You need to review stencil /pad /component design to ensure that "midship" solde
Electronics Forum | Wed Jun 30 10:24:27 EDT 2004 | K
We find keeping the work environment at about 22degC and humidity to about 40-50% is the best way to control the solder balls. Before we took measures we were out of control with solder balls especially in the summer months. We run aqueous solder thr
Electronics Forum | Fri Mar 25 10:50:01 EDT 2011 | grahamcooper22
3 deg / sec) then the flux can slump from the paste and solder is carried with it off the pad and will form balls. Finally, are your pcbs dry ? Pass a bare one through the reflow oven before you print any paste on it, let it cool and then process as
Electronics Forum | Tue Dec 19 20:01:41 EST 2000 | Lisa Murphy
Hi, I have recently been asked if I had any information on the voltage capacity of a solder ball. I asked around and did a web search but came up empty handed. Usually people are concerned with the current carrying capacity of bondwires, flip-chip
