Electronics Forum | Mon Apr 21 09:01:38 EDT 2003 | russ
Wave solder - Initially high cost but after that it is relatively cheap. Selective soldering with a solder pot such as the Air-Vac PCBRM models - Much lower cost than wave but if you get the right nozzles it is a great process. Solder preforms - s
Electronics Forum | Fri Apr 25 17:03:34 EDT 2003 | davef
Leaching. Dissolution of a metal coating into liquid solder. Leaching applies to liquid solder and, at times, is applied inaccurately to metallurgical effects, like diffusion, that occur after the solder has solidified. Please help us understand y
Electronics Forum | Fri Oct 24 20:53:53 EDT 2003 | pranav
I am re-designing a MLB Printed Circuit Board which has thro' hole chips and a BGA. I am planning to go for reflow soldering for the BGA on one side and wave soldering for the thro' hole parts on the opposite side. Is there any concern or any sequenc
Electronics Forum | Fri Apr 23 13:56:57 EDT 2004 | Robert
Hi all Does any one know problem with solder joint call crystallised joints. I have noticed that sometimes on our PCB when i look at the joints for example chips, LCCC, there are areas not smooth solder (very often in the center of the solder joint)
Electronics Forum | Fri May 07 12:02:28 EDT 2004 | Dreamsniper
From my understanding paste on BGA pads are applied only to help in holding the component as the PCB is conveyed during the manufacturing process then soldered. But during rework on BGA's do I have to apply Solder Paste or just Flux? What's the diffe
Electronics Forum | Mon Jun 07 03:03:12 EDT 2004 | Frederic
I have a question about solder paste. When the solder paste lost her tackines (dry out) how can i refresh this solder paste?. Can i add a little flux? or it is ban. I noticed that after reflow solder joints look shiny but i can see some discolour (f
Electronics Forum | Tue Aug 24 13:45:17 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Tue Aug 24 13:47:14 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Tue Aug 24 13:47:16 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Thu Aug 11 14:47:19 EDT 2005 | waynegriffin
MY COMPANY HAS AN OLD HOLLIS WAVE SOLDER MACHINE THAT WE HAVE USED LEADED SOLDER IN FOR YEARS. I WOULD LIKE TO FIND OUT THE FOLLOWING: 1.CAN THIS WAVE SOLDER MACHINE BE "DE-LEADED" IN ORDER TO USE LEAD FREE SOLDER? 2. WHAT WOULD THE COST BE? 3. NAME