Electronics Forum | Wed Feb 22 08:31:42 EST 2006 | davef
Q1 Are there any standard regulating the subject? Very few infos found on IPC. A1 We�re unaware of standards for packing and storage for most types of boards. * IPC 4553 standard for Immersion Silver Finish, 3.8 Packing and Storage. * J-STD-033 and E
Electronics Forum | Mon Mar 13 14:26:45 EST 2006 | Wave Master Larry
Well, im not sure what plane you guys are on, but I can back up my what im talking about. Ya see I wnet to Soltec traingin back in 1995 for our new wave. I got a diploma proofing that I know what i'm talking about. no one else in my company has on
Electronics Forum | Fri Mar 24 18:07:25 EST 2006 | Chris
Flash gold is just thin gold plating over electroless nickel or electrolytic nickel. Flash gold is electrolytic gold where the panel is connected to a plating rectifier and current causes the plating process to occur. Gold thickness is controlled b
Electronics Forum | Sat May 27 02:52:20 EDT 2006 | TimS
Gentlemen I have managed to pull myself together after banging my head. I am not sure the flux volume is the total solution here. All spray processes deposit flux in a similar manner, that is to say the vast majority of material sprayed onto the PCB
Electronics Forum | Tue May 23 21:14:22 EDT 2006 | davef
First, where the temperatures that aare mentioned in the original post measured? Second, it sounds like the PdAg component terminations are not seeing enough heat [your soldering iron touch-up proves this]. Your 232*C peak is the absolute minimum s
Electronics Forum | Fri Jul 13 17:16:49 EDT 2007 | jmelson
I just got a used Philips CSM84 pick and place machine for $1500. I had to widen a doorway and rent a forklift to get it inside, as well as have it shipped. So, the total cost was much higher, but still under $10 K. I may have gotten lucky on this
Electronics Forum | Tue May 01 09:58:20 EDT 2007 | rgduval
Basem, I can't direct you to a dispensing machine, as I'm not familiar with them. But, I can tell you what we do. We specialize in short volume, prototype quantity runs. Since prototypes and short quantities are not conducive to volume operations
Electronics Forum | Thu Sep 27 23:24:22 EDT 2007 | mika
Fe2+(aq) + 2e- "harply, but this is of no consequence since OH- ions are always present, even in pure water.) The cations then react with the OH- or even the H+ ions and dissolved oxygen to form a variety of compounds, which constitute rust: Fe2+(aq
Electronics Forum | Fri Oct 19 13:57:17 EDT 2007 | Michael Konrad
Hi Rob, I must take issue with your statement �By definition, no clean solder can be not-cleaned�. All no-clean fluxes can be cleaned. Whether or not one cleans no-clean depends on a variety of factors. More than eighty percent of all post reflow
Electronics Forum | Fri Nov 30 18:22:40 EST 2007 | mika
Hi Paul M, There are no silly questions but silly answers.. and here is maybe a few if I understand you correctly: If you consider place anything less than a 1.27mm (50mil) pitch component down or a chip less than a 1210, hey it maybe don't even work
winsouce.jpg)
