Electronics Forum | Tue Jan 16 11:15:58 EST 2007 | slthomas
Gaaaahhhh! NEVER mention man law and turning bottles of fine wine (metro law) in the same statement. You'll tear a hole in the time/space continuum.
Electronics Forum | Mon Jan 15 09:19:29 EST 2007 | tk380514
We use Alpha EF-2202 low-VOC No-Clean flux Selective wave soldering cassettes Bottom pre-heating wave soldering machine We have one component that will not solder properly: http://www.epcos.com/web/generator/Web/Sections/ProductCatalog/Capacitors/Ul
Electronics Forum | Thu Jan 18 12:07:52 EST 2007 | tonang
How to problem solved about production reject IC short? Please advice us about setting screen mask printer, stering solder paste, profile reflow etc Thank you for your attention and cooperation Best regard, Tonang
Electronics Forum | Fri Jan 19 14:29:19 EST 2007 | I.P. Freely
What is the part designator? A lot has to do with that. Also, is this a double sided reflow board. Perhaps you need to change your process to accept two heat cycles simultaneously. Solder thieves should work. Check the archives.
Electronics Forum | Fri Jan 19 14:32:35 EST 2007 | Mike Hunt
What pitch IC? Perhaps a nickel stencil will work. Are your board FR4? Warping the board could play a major factor in solder shorting.
Electronics Forum | Fri Jan 19 08:52:31 EST 2007 | pavel_murtishev
Good afternoon, DEK�s Pump Print is used for solder paste printing as well. Send your design to DEK and they will design the Pump Print stencil for your needs. Please note that price for pump print stencils is five times higher compared with convent
Electronics Forum | Mon Jan 22 03:51:16 EST 2007 | Bing
We are using HASL board for Press Fit, without problem in the past until recently. Now we are seeing the solder in the PTH melt and block partially the PTH hole during the reflow. It gives problem when Press Fit. Anyone has advice on this?
Electronics Forum | Tue Jan 23 23:02:36 EST 2007 | davef
Try: * Williams Advanced Materials http://www.williams-adv.com * Special Hermetic Products http://www.shp-seals.com
Electronics Forum | Tue Jan 23 16:28:14 EST 2007 | Jim
If by any chance you happen to find one, please let me know.
Electronics Forum | Tue Jan 23 16:53:45 EST 2007 | patrickbruneel
Can not be done without drastic alterations to the laws of physics Patrick
A US manufacturer of quality hand tools for those engaged in the repair, rework, R & D, testing, and assembly of electronic components and printed circuit boards from Through Hole to 2Mil Pitch Surface Mount.
98 Elm St.
Portland, ME USA
Phone: 1-207-775-6139