Electronics Forum | Tue Mar 27 18:58:36 EST 2001 | Mike Konrad
Hi Kerry, You are putting too much emphasis on the EPA�s �ENVIRONMENTAL TECHNOLOGY VERIFICATION STATEMENT� Consider the following EPA statement taken from the specific EPA report that you site: �� the end-user should contact his/her local, state,
Electronics Forum | Wed Mar 28 17:22:18 EST 2001 | billschreiber
Hello Mike, Let me try to explain the Certification vs. Verification for you. There are two EPA programs. The California Environmental Protection Agency's Certification Program where Cal/EPA Certifies the entire cleaning process for environmental sa
Electronics Forum | Fri Jun 10 09:02:58 EDT 2005 | ktron
Hi Guys.. Does anybody had experienced with designing the stencil for Right Angle LED without any dewetting problem on the LED termination? Currently our stencil opening is 1:1 and we still got so high reject due to this problem. Pls Advise, thanks
Electronics Forum | Fri Oct 31 06:55:35 EDT 2008 | andrzej
Answer on point 2 - I understand you send him gerbers of single PCB (?). In most cases you have panelized PCBs so to avoid problems with stencil first you should order PCBs and ASK your PCB supplier to send you back his gerbers of panel. There are so
Electronics Forum | Fri Jun 10 13:15:17 EDT 2005 | chunks
Hard to tell, but it looks as if this LED has no side termination, so it may only look like dewetting. If everything around this part is reflowing, I'd bet that's all this is.
Electronics Forum | Fri Jun 10 19:42:46 EDT 2005 | ktron
Thank D.B. Cooper, actually this LED has 3 sides termination but no termination at underneath of LED. So this LED tends to float rather than performing solder joint during reflow process.
Electronics Forum | Thu Oct 30 09:15:20 EDT 2008 | kingshar
Hi, Hi, 1) Can anyone tell be what is the acceptable manufacturing tolerance from stencil to PCB . 2) what are the methods we can avoid that. 3) What is the method to avoid PCB shrinkage. 4) How can we correct shrinkage 5)Is there any standard gud
Electronics Forum | Mon Sep 17 09:35:08 EDT 2001 | floydl
Based on your research, what is the pad and stencil design that you recommend for 0201 assembly?
Electronics Forum | Tue Feb 12 15:28:19 EST 2013 | pnguyvu
You need a good designed stencil. Contact Steve - He'll make a free article stencil to try out below is his contact info. Steve@usastencils.com 714-636-6211 Good luck!
Electronics Forum | Tue Feb 12 12:29:33 EST 2013 | emeto
Hello everyone, I am curious what do you think about stencil type and apperture design for better release on small appertures. I have a PCB with bunch of BGAs with small appertures. We tried with Nikel stencil using DEK's special non stick material
winsouce.jpg)