Electronics Forum | Sat Jan 04 09:02:17 EST 2003 | davef
Q1. What is the recommended stencil thickness to apply the proper amount of solder for 0603 components? A1. The proper amount of solder is determined by: * Metal content of the solder paste. * Stencil thickness. * Aperture opening. * Other factors,
Electronics Forum | Tue Mar 27 18:58:36 EST 2001 | Mike Konrad
Hi Kerry, You are putting too much emphasis on the EPA�s �ENVIRONMENTAL TECHNOLOGY VERIFICATION STATEMENT� Consider the following EPA statement taken from the specific EPA report that you site: �� the end-user should contact his/her local, state,
Electronics Forum | Wed Mar 28 17:22:18 EST 2001 | billschreiber
Hello Mike, Let me try to explain the Certification vs. Verification for you. There are two EPA programs. The California Environmental Protection Agency's Certification Program where Cal/EPA Certifies the entire cleaning process for environmental sa
Electronics Forum | Fri Aug 23 12:33:37 EDT 2019 | ameenullakhan
Hi , Its CCGA part . with normal PCB pad opening similar to other BGA pad . Yes its very surprising and we are not able to analyze. What exactly went wrong. We have new stencil design for this now. Will run it tomorrow. Will update the results.
Electronics Forum | Tue Jul 30 05:28:47 EDT 2019 | ameenullakhan
Your inputs are always valuable and help a lot. Thanks for the inputs.
Electronics Forum | Tue Jul 30 09:50:51 EDT 2019 | ameenullakhan
Attached is the image of lead lift in ccga
Electronics Forum | Fri Jun 10 09:02:58 EDT 2005 | ktron
Hi Guys.. Does anybody had experienced with designing the stencil for Right Angle LED without any dewetting problem on the LED termination? Currently our stencil opening is 1:1 and we still got so high reject due to this problem. Pls Advise, thanks
Electronics Forum | Wed Jul 24 10:07:44 EDT 2019 | ameenullakhan
Hi Team, Can anyone suggest me best stencil opening for CCGA. Attached is the component details. Solder paste : water solube - ORL0 - Jtsd 001 ( Sn63/Pb37) Any one has qualified the same. Regards, Ameen
Electronics Forum | Fri Oct 31 06:55:35 EDT 2008 | andrzej
Answer on point 2 - I understand you send him gerbers of single PCB (?). In most cases you have panelized PCBs so to avoid problems with stencil first you should order PCBs and ASK your PCB supplier to send you back his gerbers of panel. There are so
Electronics Forum | Thu Oct 30 09:15:20 EDT 2008 | kingshar
Hi, Hi, 1) Can anyone tell be what is the acceptable manufacturing tolerance from stencil to PCB . 2) what are the methods we can avoid that. 3) What is the method to avoid PCB shrinkage. 4) How can we correct shrinkage 5)Is there any standard gud
winsouce.jpg)