Electronics Forum | Wed Jul 20 16:51:03 EDT 2005 | pjc
There is a spec I read that states +/- 0.001" (0.025mm) print deposition accuracy and repeatability is more than adequate for 0201-chip printing. I don't think any print studies where done for 01005 chips yet. There are several other factors besides
Electronics Forum | Mon May 30 06:36:16 EDT 2011 | mbnetto
This is a requested point from some customers. It's part of the audit check points. But I agree it´s important for the process. You can garantee the stencil is in a good condition after many time using it. If your stencil looses the tension, you can
Electronics Forum | Mon Feb 18 12:09:17 EST 2013 | pbarton
What type of flux material does your solder paste have? I have seen difficulties when attempting to print small apertures with water washable and rosin types. Do you get a good first print and then have problems or is it the same from the start?
Electronics Forum | Fri Oct 31 06:55:35 EDT 2008 | andrzej
Answer on point 2 - I understand you send him gerbers of single PCB (?). In most cases you have panelized PCBs so to avoid problems with stencil first you should order PCBs and ASK your PCB supplier to send you back his gerbers of panel. There are so
Electronics Forum | Mon Feb 18 15:53:56 EST 2013 | emeto
No Pete, problems start with very first print.
Electronics Forum | Wed Aug 16 12:49:30 EDT 2000 | Bill Schreiber
Phil, I know it must be frustrating to try and weed through all of the hype that is put out by various stencil cleaner manufacturers. However, there is some impartial published data available. An article by Richard Clouthier (now with Photo Stenc
Electronics Forum | Fri May 11 15:12:00 EDT 2012 | bwjm
Hi Guys, I need some help. I was running prototyping volume previous and my SMT line uses manual printing. Business has picked up and i started to get higher volume 300 to 500 pcs each model. I am running a small firm and have only a small sum of cas
Electronics Forum | Tue Feb 19 03:02:01 EST 2013 | pbarton
No Pete, > > problems start with very first > print. OK, So what is the flux type in your paste?
Electronics Forum | Wed Jan 13 20:44:42 EST 1999 | Steve Gregory
Hello Sanjay! The cheap deal I use that Earl spoke of is called a SMarT Measure. It's a depth measuring microscope that uses the same principle of measuring optical focus that the units from Vision Engineering do ( if you've ever looked at any
Electronics Forum | Thu May 01 15:08:52 EDT 2003 | k_h
If Kapton tape doesn't work, I would recommend eating a few hundred bucks and ordering a new stencil. I think your asking for more trouble trying to plug the apertures with dried paste, glue, or anything else. It will dislodge sooner or later and pro
.gif)
winsouce.jpg)
