Electronics Forum: stencil (Page 506 of 540)

Re: roll type of cleaning wiper

Electronics Forum | Sun Apr 18 19:16:28 EDT 1999 | Wayne Bracy

Please visit our Web site, especially 'link page', to get some hint for roll typr of cleaning wiper for automatic screen printers. http://www.squeegee.co.kr Idiot: I wouldn't visit your site if I had to start using toilet paper. K

Re: Reballer fro BGA

Electronics Forum | Fri Jun 04 12:18:48 EDT 1999 | Gary Miller

Any recommendations for a reballer for BGA and mBGA? Low volume, low cost appreciated! Dave: I don't believe that reballing BGAs that go into customer products is a good idea. Check with your BGA supplier to determine their recom

Re: About the current issues of surface mount devices

Electronics Forum | Tue Apr 13 23:35:44 EDT 1999 | Jeff Sanchez

Hello. I'm now investigating the current technological issues on surface mount devices. For example, I want to know the limitation of the surface mount machine. Where can I get the materials for this purpose?

Re: About the current issues of surface mount devices

Electronics Forum | Tue Apr 13 23:41:15 EDT 1999 | Jeff Sanchez

Hello. I'm now investigating the current technological issues on surface mount devices. For example, I want to know the limitation of the surface mount machine. Where can I get the materials for thi

Re: Intrusive soldering

Electronics Forum | Tue Mar 23 04:07:44 EST 1999 | Scott Davies

Rob, We are also using intrusive reflow to simultaneously process SMT and Thru-hole components. Our arrangement goes as follows: - Screen print solder paste to the single sided PCB using 0.008" laser cut stencil. - Apply adhesive dots to selected

Re: Intrusive soldering

Electronics Forum | Thu Mar 25 14:00:45 EST 1999 | Bob Willis

Rob, We are also using intrusive reflow to simultaneously process SMT and Thru-hole components. Our arrangement goes as follows: - Screen print solder paste to the single sided PCB using 0.008" laser cut stencil. - Apply adhesive dots

DEK fine pitch autoflex pin breakage

Electronics Forum | Fri Mar 19 19:05:27 EST 1999 | Earl Moon

Folks, I think we are getting closer to being very happy with DEK stencil printers of the 265 GSX variety. However, problems continue arising concering fine pitch autoflex tooling pin breakage. We are told by the British engineering establishment,

BGA repair/rework

Electronics Forum | Sat Mar 06 10:25:55 EST 1999 | Earl Moon

I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. Concerning the BGA stuff, I'm getting about 60% success using this rewo

Re: Solder Paste Vs Solder Paste Cartridges

Electronics Forum | Mon Feb 22 13:39:22 EST 1999 | Justin Medernach

Can anybody give me the Pros and Cons of of using Cartridges over jars and/or vice-versa. Also, if using cartridges, what is the best way to keep the paste from seperating, short of buying a mixer that cost over $5000.00 Thanks, Bill Bill,

Fuji GSP-II For Sale

Electronics Forum | Wed Feb 17 17:40:42 EST 1999 | Jerry Stafford, Jr.

Well I don't know if this is advertising or not but the registration area is down so I can't post to the used equipment section. We have a Fuji GSP-II-4000, S/N 1723, December 1993 for sale. This machine was barely used on a military project that i


stencil searches for Companies, Equipment, Machines, Suppliers & Information