Electronics Forum | Sat Apr 21 08:26:57 EDT 2007 | Cmiller
Has anyone experienced a problem with conformal coating adhesion to IS-410 boards? We are having problems with one suppliers boards. IS-410 boards from other suppliers are fine and all FR-4 boards that I have looked at are fine. We are using Conap
Electronics Forum | Mon Jan 21 19:22:38 EST 2008 | davef
In your situation, the issue is the compatibility of your flux residues and the encapsulant that you choose. First, contact your encapsulant supplier for advice. They've likely been down this road with other customers and may be able so save you som
Electronics Forum | Wed Feb 13 09:17:47 EST 2008 | scottp
The causes of voids are extremely paste dependent. I did a literature search a couple years ago and the papers all disagreed with each other - one would say turn knob "A" to the right and the next would tell you to turn it to the left. I did my own
Electronics Forum | Fri Feb 29 08:12:56 EST 2008 | davef
Solder paste suppliers often make recommendations on solder paste handling after removing it from the container [eg, jar, cartridge, etc]. For instance, Multicore Solder Paste Handling Guidelines, September 2004 says: As a general rule, paste that h
Electronics Forum | Thu Apr 17 10:44:24 EDT 2008 | rculpepp
I'd suspect contamination also, possibly from the board supplier. Sr. Tech's post mentioned what looks like a blister on the board, in the upper right of the Q19 photo. This could very well be a contaminate from the PWB fab shop. I've seen similar pr
Electronics Forum | Thu Jun 26 20:54:08 EDT 2008 | davef
As pointed-out above, the downside of telling your supplier how to perform a process can create problems: * It sets the cost of the operation ... I did what you told me to do * Materials selected may be incompatible ... I did what you told me to do *
Electronics Forum | Wed Apr 08 14:46:34 EDT 2009 | boardhouse
The things to ask your board supplier would be: 1) Was the Pre-preg material that was used on this board within its Shelf life? and ask for the Incoming inspection CofC for the Pre-preg material. 2)Was this order shipped from Stock - this is why
Electronics Forum | Mon Jun 13 07:20:10 EDT 2011 | scottp
It's more likely the warp is due to material issues. I've spent way more time than I'd care to admit running Thermoire with various profiles and there's pretty much nothing you can do to reduce warp via profile unless your current profile is truly a
Electronics Forum | Fri Mar 17 21:38:55 EDT 2017 | jlawson
I think the main driver is MTBF data driven by the Car OEMS, mainly german makers pushing this onto suppliers in supply chain. Vacuum soldering and void reduction is a hot topic for the leading electronics suppliers in Germany at the moment. Is not r
Electronics Forum | Wed Jul 28 16:36:30 EDT 1999 | Earl Moon
| | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That w