Electronics Forum | Sun Sep 10 10:48:46 EDT 2023 | mekmat544
Hello, I have litle bit simply question. I have silver conductive glue in small syringe. Can you help my how should I mix this glue in syringe before using? Thank you. M.
Electronics Forum | Mon Sep 11 07:36:04 EDT 2023 | tommy_magyar
See attached snippet from a datasheet: Syringe 1. Twist and remove the cap from the syringe. Do not discard cap. 2. Measure 1 part by volume of A. 3. Measure 1 part by volume of B. 4. Dispense material on a mixing surface or container, and thoroughl
Electronics Forum | Tue Sep 12 14:01:44 EDT 2023 | bryangomez
Thanks for the info..
Electronics Forum | Wed Nov 06 10:17:45 EST 2002 | davef
In order from best, better, good * Lowest purchase price: cartridge, jar, syringe * Ease of inventory control: cartridge, jar, syringe * Flexibility of use: jar, syringe, cartridge * Ability to dispense by hand or machine: syringe * Cost to get paste
Electronics Forum | Wed Nov 06 12:11:29 EST 2002 | russ
On this I was thimking of cartridges and not syringes.
Electronics Forum | Wed Dec 12 11:22:52 EST 2001 | davef
WOW, a 300ml syringe!!!! Now, that is one BIG-assed syringe. [I assume you mean �30ml�] Thoughts are: * Buy through distribution, for instance http://www.loctite.com/distributor/ * Buy your cases in smaller syringes. 10 & 30ml syringes are standar
Electronics Forum | Tue May 20 11:32:38 EDT 2003 | JB
So far we haven't had any problems with air in the syringe, but in the process of replacing the old syringe is were we had the problem. I'll keep your tip in mind if we ever have the need to get air out of a syringe though. Thanks for the info. JB
Electronics Forum | Tue Jul 18 18:08:08 EDT 2023 | davef
Vote for: JBC DPM Paste Dispenser Manual Also consider: Metcal 910-MSG Manual Syringe Gun-Kit Spoty micro-dot solder paste syringe dispenser [ https://www.tindie.com/products/avandalen/spoty-micro-dot-solder-paste-syringe-dispenser/ ]
Electronics Forum | Tue May 20 05:01:27 EDT 2003 | gavinscott
Hi, I have had this problem in the past and the best method I found was... Before removing the old syringe and fitting a new one, ensure the viton tubing is doubled over and pinched. This will help to eliminate any airlocks in the viton tubing whic
Electronics Forum | Thu Nov 07 04:24:24 EST 2002 | Yngwie
Thanks for the reply guys...It was much appreciated. On syringe or Cartridge - what about the impact of flux migration, there was a talk about, periodically we need to turn the cartridge or syringe upside down to ensure the metal content & flux are a