Electronics Forum | Wed Feb 20 15:20:34 EST 2013 | hegemon
Depending on your requirements, you could range from a hair dryer, heat gun, toaster oven, hot plate, on up to digitally controlled surfaces and convective systems. You'll have to gauge for yourself whether you are just trying to add some heat energy
Electronics Forum | Thu Feb 28 10:40:56 EST 2013 | rway
I have been doing this since day one of getting the AOI. It just seemed logical. I don't know what type of AOI you have, but what I have found works best is to use solder inspection to catch parts that are loaded into a no-load location. Move the
Electronics Forum | Sat Feb 23 16:49:49 EST 2013 | joeherz
Appendix A2 of the standard says: ----------------------------------- B. Temperature controlled soldering equipment (at rest) should be controlled within +/- S'C [+/- 9'F] of the idle tip temperature. Constant output (steady output) tools in compli
Electronics Forum | Wed Mar 20 16:10:27 EDT 2013 | woodsmt
Most pots have a drain system, but that is a scary thing to use. I have seen places that have plumbed it nicely with ball valves and such to control the flow into small containers, but still fraught with danger. I use small metal bread pans. I lad
Electronics Forum | Tue Apr 02 12:53:47 EDT 2013 | microaide
I have entered my machine configuration as much as I can figure it out. I will have two machines. One with tape feeders, and the other with vibratory (tube) feeders and a waffle feeder. I've tried to set this up as best I can. But I get to the screen
Electronics Forum | Wed Apr 17 16:51:55 EDT 2013 | gosswald
I have not been on this site for a while but I was reading your post on Autoprgram. I have had my share of fun with this program getting a Quad 2C to run I purchased a while back. I had originally tried the DosBox approach but ran into all kinds of
Electronics Forum | Mon May 13 10:08:44 EDT 2013 | rgduval
I've heard that MyData is no longer supporting the TP's, so, getting a new motor might be a difficult proposition. If you can find the motor manuf/part number on the motor itself, you can likely find it on line somewhere...Google the p/n should do i
Electronics Forum | Thu May 30 10:06:20 EDT 2013 | rgduval
In general, it would not be advisable. DI water is used for a couple of reasons. First, the missing ions aid in the cleaning process, as they seek to bond with the material on the board, allowing the water to act like a fairly aggressive solvent.
Electronics Forum | Thu Jul 18 12:44:24 EDT 2013 | ericrr
after checking two computers, did not find it. However after using "google" found it in a flash. (less than 0.22 seconds) using a spreadsheet. how about this for resistor & capacitors with 4mm pitch, all measurements in millimeters. cell A1 "input
Electronics Forum | Fri Aug 09 17:34:16 EDT 2013 | hsielemann
I am looking for anything about the Amistar / Tenryu MT5800VL. Manuals, schematics, add-ons, software or even contact information about people who might have something. Thanks! *** Update 22.08.2013 I got the maintenance manual, parts list for the