Electronics Forum | Sat Jul 29 13:30:17 EDT 2006 | Chunks
Some have a bottom side adaptor plates with pins to make contact to certain areas of your board. The top side may have one or multiple heads that can move the entire area of your board. On each of these haeds is a pin like that from an ICT machine.
Electronics Forum | Thu Aug 03 10:13:41 EDT 2006 | wrongway
Hello Rush fan we have a Ekra E5 had it about a year the only thing I dont like is the foil on top of the doard holders you can take them off but if your board is warped then it dosnt clamp the board and it will fail the vision but we hav
Electronics Forum | Mon Aug 07 09:04:09 EDT 2006 | molos21
Hi everyone, I am starting to use the lead free process and I had a few wetting problems (solder did not reach top side) at the wave soldering process once the pcb had passed our smt line (one heat pass). From what I understand, I have had a problem
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Thu Aug 17 17:36:08 EDT 2006 | slthomas
I don't have any data (haven't tried this), but it doesn't take much thought to see that determining the risks associated with simultaneously applying compressive and rotational forces to the end of the barrel, not to mention chewing up the copper, i
Electronics Forum | Fri Aug 18 11:26:08 EDT 2006 | Board House
Hi Mark, Couterbore is possible in two way's during PCB Manufacturing. Couterbore plated and non-plated. Meaning that the entire hole will either have to be Plated or Non-Plated. Prefered Methode is Plated, to accomplish this your PCB house would
Electronics Forum | Mon Aug 28 09:20:42 EDT 2006 | pr
Yeah, changing it while you run is ridiculous. I would take my thinnest part and play with the thickness, until you make it as thick as you can (and still place the part with good results). Then use that thickness for all. You can put a dial indicato
Electronics Forum | Tue Aug 22 15:26:39 EDT 2006 | fastek
I certainly would not buy off any product from a manufacturer that is for sale. Imagine they have known they were going to do this for some time now and all of the cost cutting and apathy that is occuring at this time does not bode well for their cus
Electronics Forum | Wed Aug 30 23:45:23 EDT 2006 | ppcbs
Since BGA's are sensitive to contamination in the plating process, I always do a simple solderability test whenever we receive a new batch of boards. Take a board from the batch, apply no clean flux on the BGA site, then try to tin the pads with a m
Electronics Forum | Wed Aug 30 23:45:40 EDT 2006 | ppcbs
Since BGA's are sensitive to contamination in the plating process, I always do a simple solderability test whenever we receive a new batch of boards. Take a board from the batch, apply no clean flux on the BGA site, then try to tin the pads with a m