Electronics Forum | Mon Sep 03 21:49:26 EDT 2018 | aemery
Maybe your CMOS battery is dead! On some of these old system once the battery is drained the CMOS settings are lost, this would include the correct setting for detecting the hard drive and I doubt there is an auto detect . Try turning on the machine
Electronics Forum | Wed Mar 28 11:05:33 EDT 2018 | dleeper
I had a DOS Heller 1500 a looooong time ago so my memory is fuzzy. That being said I remember there were some weird options in some of the configuration menus. I don't remember the names, but its were you would set the alarm points, you could manual
Electronics Forum | Fri Mar 02 08:33:43 EST 2018 | dwl
40 parts per board multiplied by half a million per year is 20 million placements per year. That’s serious production. The machine is rated at 7500 placements per hour, so running 24/7 that’s 111 days per year. The rated placement rates on pick and
Electronics Forum | Tue Jun 26 11:24:41 EDT 2018 | applebar
We are a very small EMS that has been sued by a large OEM customer. We built a board, it passed the customer supplied tester, but we had accidentally put a wrong part on it. This was discovered years after we had been placing this part. The cust
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Fri Jun 07 11:39:33 EDT 2019 | gregoryyork
I feared so. The only thing to be done is to tell the PCB manufacturer to increase the Thermal cure so dont set the oven to 150C but to 170C and actually measure the middle board and once it hits 155C then give it an hour cure from then. Also insist
Electronics Forum | Wed May 15 09:33:16 EDT 2019 | kahrpr
All manufactures ratings on machines are way over blown. I am not shilling for Hanwha we have there equipment it runs good our SM471 averages 36k to 42k. there is so much that goes into how fast a machine runs such as board design type of parts, pane
Electronics Forum | Mon Aug 19 13:32:54 EDT 2019 | aqueous
ROSE testing a post-reflow assembly which has been reflowed using no-clean flux may not yield information that is helpful. No-clean flux technology works by encapsulating the flux's activators and other chemical constitutes that would be harmful if l
Electronics Forum | Mon Dec 30 12:55:37 EST 2019 | emeto
We saw your profile, which in my opinion looks alright based on the guideline from the vendor. Can you tell us more about the joints that you cleaned? Are they showing nice wetting and nice and shiny finish? How about your stencil thickness? From my
