Electronics Forum | Tue Jun 13 10:33:48 EDT 2017 | simons
Yes. All amps were properly programmed and tested with another Samsung machine. In addition head #1 Z-axis motor was also swapped out. Simon
Electronics Forum | Fri Jun 09 07:32:13 EDT 2017 | bukas
it sounds to me like a home sensor. try adjusting sensitivity if possible. move head manually to determine position at which home sensor is activated
Electronics Forum | Mon Jun 12 11:14:10 EDT 2017 | bobpan
Sounds to me like the z-encoder could be a problem. I cant remember but you may be able to disable a head in the system settings. Bob
Electronics Forum | Wed Jun 21 21:28:34 EDT 2017 | maddy
Hi We had same issue with Head 2.if you find solution let me know as well. thanks
Electronics Forum | Wed Jan 23 07:42:34 EST 2019 | rolfi
Hi, we had the same issue with our CP30V and head1. Did you solve the problem? Please let me know as well. Thank you.
Electronics Forum | Thu Jan 24 09:09:46 EST 2019 | protokos
Hi Kathy i had the same issue yesterday and find that a spring is not ok. and i also clean the sensors this was fixing the problem for me.
Electronics Forum | Thu Jan 24 12:09:08 EST 2019 | palsrvs
Wil, Thank you so much! So appreciated!! The spring makes sense. We will check these items.
Electronics Forum | Fri Jun 09 14:27:50 EDT 2017 | jdengler
This is a current model from Manncorp, why don't you contact them? Jerry
Electronics Forum | Mon Jun 12 01:44:02 EDT 2017 | bukas
it looks like it has something like rising table to push board against stencil...
Electronics Forum | Tue Jun 13 07:22:50 EDT 2017 | emeto
If these are snuggers(locking PCB from the side) that means one or two of these handles move the Z table up and down. Is there any air going to this machine that you diddn't connected? Or your pins underneath might be adjustable.