Electronics Forum | Sat Aug 25 11:54:48 EDT 2012 | dan_ems
Hello, I already build such a system with hardware and software from National Instruments. I think is the best solution because you can buy for the start only a Multimeter (DMM), a multiplexer and a software. Is very easy to do the programming but
Electronics Forum | Mon Aug 27 08:16:23 EDT 2012 | rway
No, in his case an ICT in not out of the question. An ICT, especially with many passive components, can give you piece of mind that the assembly was built correctly. Even with the addition of an automated insertion machine, you still run the risk o
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Sun Aug 19 07:59:06 EDT 2012 | processman
Thanks for the replies guys. Interesting the one with the dryer in the air supply, will look into this. Sure some of our service guys lightly grease the O rings within the spindles, have been trying to get them away from this. Also interesting to h
Electronics Forum | Tue Aug 21 13:24:50 EDT 2012 | cyber_wolf
As a side note: A lot of machine manufacturers call out IPA as a "degreaser". As an experiment put a dab of grease in a container with IPA then put some in a container with mineral spirits. Shake them up and see which one dissolves the grease. It's
Electronics Forum | Tue Aug 21 06:26:26 EDT 2012 | headlad
I've had a CM202DHU since new (10 years) and it is a very reliable piece of kit. I wouldn't be happy placing 0201's but if you use 110 nozzles it is capable. Just make sure that you always line up the feeders prior to running or all you'll here is mi
Electronics Forum | Wed Aug 22 14:18:49 EDT 2012 | tombstonesmt
I would recommend you purchase a nozzle from Count On Tooling if you plan on placing 0201's. It is possible but as mentioned there will problems with provided nozzles from Panasonic. Again, as mentioned, you have to teach the pick up position everyti
Electronics Forum | Tue Sep 18 05:54:02 EDT 2012 | sarason
Have you got some modern software to load the unit. My program PCB Synergy can do some of the Panasonic formats but not this one. It takes less than a day to write if you have some files for me to reverse engineer and the file you read it from. Any
Electronics Forum | Thu Aug 23 21:53:47 EDT 2012 | padawanlinuxero
Hello We use the service from Daleba Electronics to tell you the truth dont know where they fab the pcbs, but we have a long relation with them and we dont have any big issues with them, if you want try to talk to Brian Thain brian.thain@daleba.c
Electronics Forum | Wed Aug 22 17:32:21 EDT 2012 | icin
I recently heard an interesting requirement and wanted to poll the fine members of this forum for what their interpretation would be, and if any standard would exist: "Maintain the bill of material in an anti-magnetic environment." Thanks in advanc