Electronics Forum | Thu Oct 27 01:17:33 EDT 2005 | adlsmt
You should also check out YesTech. Both companies should give you in house demo's and be willing to leave a machine there to try out for 30 days. They are with out a doubt only as good as the programmer. I think the support from Yestech would be bett
Electronics Forum | Mon Oct 24 17:56:57 EDT 2005 | Ali
Hello all: A couple of queries on matte Sn plating: My Application: 2 Reflows in subassembly reflow+ 8 Hr Steam age+ Solderability (Dip and look) for sub assembly to mother board soldering. Queries on Matte Sn: 1- Different plating vendor
Electronics Forum | Tue Oct 25 07:32:12 EDT 2005 | prakash
My company provide service in terms of repairing the cognex vision card used in the Dek 265 GSX and 288 machines, and certain MPM and Camalot machines. I believe the Gemini II uses the 5000/5200 series vision card. Do contact me if you're interested.
Electronics Forum | Tue Oct 25 09:20:10 EDT 2005 | meritajs
Hi, We have problem with y-axis offset at YM84 After setting the ORIGIN machine operate exactly but after sometime y-axis recieves offset bis 5-10mm.After repeated setting ORIGIN Y-coordinat became exact. The same things take place if we operate in W
Electronics Forum | Tue Oct 25 22:54:55 EDT 2005 | KEN
sorry. re-read your post. The problem is the home sensor relative to the home pulse. You're catching the wrong home pulse. a 10mm offset sounds about right for a 360 degree error. You need 50% +/- 15 % to ensure you always zero to the same phys
Electronics Forum | Tue Oct 25 22:28:27 EDT 2005 | KEN
I have never heard of heating boards prior to v-score. Have you established any trends on component orientation and cracking? What is your v-score thickness range? Do you have your blades regularly sharpened? Have you measured your blade alignment?
Electronics Forum | Wed Oct 26 10:21:28 EDT 2005 | russ
We are also experiencing problems with this thick stiff paper tape. Our problem is the strength of the spring that supports the tape at its pick position. After a while it just pushes it down because the tape exit wants to bend the tape too sharply
Electronics Forum | Thu Oct 27 09:23:36 EDT 2005 | rlackey
Hi Russ, Kemet - http://www.kemet.com/kemet/web/homepage/kechome.nsf/vapubfilesname/F3102CE.pdf/$file/F3102CE.pdf You want page 29 of 30 of this PDF Murata - http://www.murata.com/catalog/c02e11.pdf Page 132 of the catalog, or 134 of the PDF.
Electronics Forum | Wed Oct 26 10:35:04 EDT 2005 | mmjm_1099
Hello all, I was wondering if anyone is using a program or steps for converting your bill of material to a lead-free state. I am looking into changing some of my current customer based parts to lead-free but was wondering if theres a simplier ste
Electronics Forum | Tue Nov 15 14:31:59 EST 2005 | Samir Nagheenanajar
Back in the days when I was in charge of a Paintline Dip conformal coater, I had the same issue with a non-hermetically sealed Potentiometer. We tried to use rubber boots, but the capillary/wicking action of our silicone-based heat cured coating was