Electronics Forum | Wed Nov 09 10:08:42 EST 2011 | julien
Hello all, We have an old batch cleaning machine in our production and we use isopropanol alcohol during the rinsing process probably to lower the surface tension. Right now we are looking for a new machine who can do a better job compare to the ol
Electronics Forum | Fri Nov 11 01:48:05 EST 2011 | julien
Thanks guys, But for the cleaning process we already have a chemical product to clean flux residues and other contaminant. But it seems that we can't rinse properly under low stand-off components and we find trace of our chemical under some ceramic c
Electronics Forum | Fri Nov 11 07:43:30 EST 2011 | davef
On cleaning under low standoff components: How about reading the papers that Mike kindly posted for you above? It's intended to answer questions about cleaning under low standoff components. On conferences, exhibitions, and shows: The BIGGEST show o
Electronics Forum | Thu Nov 10 09:25:54 EST 2011 | kevinemslie
We have had an issue where a turnkey company has a solderability issue with boards that we supplied. The most thorough way of proving thay the boards work in my opinion is to take a bare panel randomly from the batch (same date code) to have it paste
Electronics Forum | Fri Nov 18 08:35:20 EST 2011 | bobpan
try this..... I think there is a coupling for the theta motor....make sure both set screws are tight.....maybe the theta is slipping. Make sure there are no bright lights shining into the machine....maybe even throw a dark cover over the top and try
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Tue Nov 15 15:37:05 EST 2011 | comatose
I have a new (to me) Vitronics XPM3 oven which we're hooking up. It requires 480V, and I only have real 208V in the facility. I have a transformered up 480 subsystem, but its corner grounded rather than center grounded. The XPM3 manual suggests tha
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
Electronics Forum | Sun Nov 20 18:15:24 EST 2011 | xborre
Hello, We are about to buy a old used Dima Optimat P&P I have already read the manual to know more about the possibilities. I have read it can place SOT23 packages, but i'm currious if it can recognize and place also the 5 pin variant (SOT23-5) and
Electronics Forum | Mon Nov 21 10:51:12 EST 2011 | scottp
I've never seen a good article with a definitive explanation - just speculation that the increased wetting forces due to nitrogen result in increased tombstones. My own experience is that nitrogen is a very minor contributor to tombstones and can pr