Electronics Forum | Sat Oct 05 23:03:05 EDT 2013 | tonnyneoden
Dear Jvadillo, Ok,it doesn't matter ,thank you for your reply. We are researching and developing our new machine which have vision systerm can ensure the precision about mounting for a long time .Maybe will come into the market next year and hoping
Electronics Forum | Sat Oct 05 23:05:04 EDT 2013 | tonnyneoden
Dear Jvadillo, Ok,it doesn't matter ,thank you for your reply. We are researching and developing our new machine which have vision systerm can ensure the precision about mounting for a long time .Maybe our new machine will come into the market next
Electronics Forum | Thu Sep 19 10:15:36 EDT 2013 | sara_pcb
We have a PCB to be populated using reflow soldering. The board contains lead free BGA device(11x11, 1mm pitch ) and Standard SMT devices which are not lead free. Since profile temperature is different for both devices, our contract assembly house is
Electronics Forum | Fri Sep 20 08:38:30 EDT 2013 | cyber_wolf
There is a method and let me stress that you need a competent wrench man to do this.It does require a "crows foot" jig that you can probably get from a used equipment dealer. The proper way to clean the clutches is to remove them from the ring gear.
Electronics Forum | Fri Sep 20 13:44:17 EDT 2013 | cyber_wolf
There is no 8mm wrenches involved. The procedure is a little to extensive to post.The only hand tools required are the crows foot jig a set of allen wrenches and an adjustable wrench. You have to remove the shaft crown to get the clutch out. Again..
Electronics Forum | Sun Oct 06 12:28:08 EDT 2013 | christian01976
Hello. I just can say: buy it! We have some older Yamaha machines (Assembleon in europe). Topz X2, two Opal X2 in line and a line of MC24 (YS24) and MC1 (YS100). And those machines are really good. I have no bad things to say about them. Greetings
Electronics Forum | Mon Sep 23 12:59:12 EDT 2013 | pauldavis4
New pcba supplier sent us first article pcbas (SMT, Wave & hand solder operations) that failed our testing due to no-clean flux residues found under ICs and around passive capacitors. Second lot came in and had 100% pass yield, but we still see a cl
Electronics Forum | Wed Sep 25 16:08:47 EDT 2013 | nophsem
The game doesn't end, bobpan! When I changed SRX boards, turn on the machine and doesn't indicates Motor error #5 and head initialize at home. I upload a program, I put the PCB to start, then RUN and head stay paralyzed halfway between HOME and PCB,
Electronics Forum | Wed Sep 25 11:12:48 EDT 2013 | derekj
Hello all. Running a new to us Omniflo 5 and realized that there is no ports for thermocouplers or wires to do any profiling. There is a space on a front panel for thermal profiling inputs, so I am assuming it was optional, just not spec'ed on this m
Electronics Forum | Thu Sep 26 15:51:14 EDT 2013 | jdengler
We use JBC here. I like the response time of the iron tip. When soldering, the tip temperature does not drop as much as the Weller's we used to use. I like the ease of changing tip sizes. I dislike the cost of replacement elements. The tip and