Electronics Forum | Mon Dec 19 21:34:47 EST 2022 | stephendo
To add to that we once had to replace the gaskets in a very old oven. We couldn't find any so we used a high temperature sealant. And then realized that they weren't gaskets originally, it was originally sealed with high temperature sealant. After it
Electronics Forum | Wed Dec 21 10:07:06 EST 2022 | gillesderruau
Hi I can send you soft : scp2.290_5.246 (MMI2.290, VME5.246, VIS4.112(1.7.5), Opti5.931 IT system 1.610)& scp2.290_5.247 .................. scp2.290_5.247 (MMI2.290, VME5.247, VIS4.112(1.7.5), Opti5.931 IT system 1.610) . - Operations manual (337
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Thu Dec 29 14:09:45 EST 2022 | proceng1
Your best source of parts and info for MPM machines is PPM in New Hampshire. George, who is the oracle when it comes to these printers is no longer with the company, but either Ed Sullivan or Steve Brown can probably assist you. I had a UP1500 and
Electronics Forum | Fri Dec 30 20:12:47 EST 2022 | ttheis
I found a broken COM3 connector on the fluxer interface board where the PC comms go through and replaced the connector. Now when trying to establish communications the exhaust fan turns off briefly a few times then it times out and reports a failure
Electronics Forum | Tue Jan 03 12:33:23 EST 2023 | stephendo
Is there any RS232 to USB involved with the machine? I'm guessing that it is a new to you machine that had been running before you bought it. We had an oven like that that would not find the machine. I noticed that a setting had been 2 then later w
Electronics Forum | Thu Jan 05 08:53:21 EST 2023 | tommy_magyar
Check manufacturing date code (if you can) on the reels against your receipt of the material. If you are a contract manufacturer you could make a supplier quality claim if they have sent you expired components (and you did not know). A relatively eas