Electronics Forum | Fri Jun 14 13:43:02 EDT 2013 | rway
The low value will be 0.624uF. You have to factor it from the low tolerance (-10%). So: 0.9 x 0.92 (machine tolerance) x 0.91 x 0.91 x 0.91 (3 decade aging factor for X7R dielectric). We factor hours at the 3rd decade (10,000 hours), but you can
Electronics Forum | Tue Jun 18 09:51:53 EDT 2013 | rway
If they're 1 1/2 years old, they are definitely aged parts. Either send them back for newer or widen your tolerances on the ICT to compensate. You are at the 3rd decade now (10,000 hours) and you will need to compensate for this. These parts are n
Electronics Forum | Wed Jun 12 13:27:28 EDT 2013 | joeherz
Our customer wants to do an overmold operation (3rd party to us) on the non-populated side of a rigid flex assembly. Their inquiry below: "We are going to end up over molding plastic over the back of this rigid flex to form an enclosure but wanted
Electronics Forum | Wed Jun 12 14:42:40 EDT 2013 | armandogomez
Hello guys ! I am here again with a problem, right now we have a problem with a new product, the problems are with voids with the PTH we put a receptacle with terminal blades that are 1.3mm width in a pth with a diameter of 1.5mm we use a pallet to
Electronics Forum | Mon Jun 17 19:10:04 EDT 2013 | hegemon
You have not mentioned exactly how the BGA was reflowed onto the board. Was it sent through the oven again after the mini-stencil, or was it heateed up and reflowed using a BGA rework station, or other hot air device?? From the sound of it (outside
Electronics Forum | Mon Oct 21 19:17:23 EDT 2013 | hegemon
The first picture shows an issue. Note that the vias adjacent to the interior rows are filled with solder. At the outside rows this is not evident. What you might have are interior spheres that are smaller in volume than the rows on the outide, si
Electronics Forum | Thu Nov 07 15:06:11 EST 2013 | hegemon
1st X-Ray looks pretty good. One instance of what looks like solder migration in the lower left quadrant. 2nd X-Ray shows a number of locations where the solder has migrated into the vias, shown by the small dark circles between the main spheres.
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Sat Jun 22 05:40:36 EDT 2013 | lkavan
Hi friends, I am sorry that I boring you again, but I hope somebody can help me... I have a problem with servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some servo loops are unstable, motor is shaking. It is problem with driver, when I change
Electronics Forum | Tue Jun 25 10:16:41 EDT 2013 | davef
Hi Ryan: I assume you mean reel ... the plastic thing that contains taped components. Tape & Reel, Reel suppliers: * Advantek advantek.com/products/packaging-reels.php * Peak International peakinternational.com/tape.html * Acrotech Southwest, Inc.