Electronics Forum | Thu Aug 27 17:40:11 EDT 1998 | Earl Moon
| Does anyone have any experience they are willing to share on Ag epoxy used as a copper through hole plating replacement? Was CEM3 used? | What are the limitations? | Thanks, | Steve Steve, Hello again. Hope you guys (Intel) aren't going to do that
Electronics Forum | Wed Dec 09 18:51:06 EST 2020 | johndep7
My company has been having issues with a lot of solder balls, solder splash, and flux balls all over a specific board. Now this is one of the only companies that require us not to clean our boards after our work is finished but this is also causing a
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Mon Dec 02 16:19:11 EST 2002 | slthomas
Unfortunately it's nc or we'd be worrying about this on the fly. Non-contact is defintely and issue....this is an 18"x9" board with 1500 bottom side SMT parts that are scattered among the through-hole and vice-versa. We're currently using 7 hold-
Electronics Forum | Thu Aug 13 12:55:46 EDT 1998 | Dave F
| Hi, can you please tell me how to make green coating and through-hole plating of PCB? Thanks! | Xingsheng Xingsheng: Welcome. Bible on PCB fabrication: Printed Circuits Handbook, Clyde Coombs, McGraw-Hill Web resources: http://www.pwbrc.org/ a
Electronics Forum | Mon Jan 15 11:41:56 EST 2007 | davef
Questions are: * Does the component take solder when you dip it in the solder pot to test the solderability of the leads? * Can you get full barrel fill when wave soldering a bare board? * Is your flux reaching the top of the board through the hole b
Electronics Forum | Tue Jan 22 20:34:41 EST 2002 | davef
Other on-line electronic assembly sites have no juice. This is it. We have wave soldered since 1982. What's the issue?
Electronics Forum | Thu Jan 24 04:06:12 EST 2002 | wbu
Shawn: So, when was your last solderanalysis and what were the results ? Did this phenomenom occur just so, out of nowhere, and is it with all your boards? Just missed these points in your request. Wolfgang
Electronics Forum | Tue Mar 15 16:51:59 EST 2005 | Praveen
Hello: I am looking for papers/information on correlation between lead protrusion and reliability studies conducted on Through-Hole Technologies. I would really appreciate it if information on the same could be made available. Thanks and have a nic
Electronics Forum | Fri Jul 07 03:27:31 EDT 2006 | dougs
Hi folks, thanks for all the tips. We have run our first batch of these flexi boards now. I had the PCB suppliers make me some 1.6mm FR4 carriers to lay the boards on to carry them through the process. (1 flat & 1 with cutouts for the second side)