Electronics Forum | Tue Feb 01 01:01:19 EST 2011 | jeffr
The YAMAHA manual is not much better. Topaz is slightly harder to calibrate than the later machines due to the machine being fussy about the lighting. Remember that you must setup the QFP68 both in the program for placement and also in the Database f
Electronics Forum | Mon Feb 20 20:28:04 EST 2012 | acsscott
Have you done any more work on this? I have a program that reads the Altium files, a feeder database,and makes a UFOS file for the older CSM machines. I can't get the UFOS to VIOS convertor on our Topaz X to read the UFOS *.BRD files. It stops and
Electronics Forum | Fri Jan 16 19:02:55 EST 2004 | Frank Gearhart - Assembl�on Snr. Software Technical Specialist
The OS/2 software you are referring to is the CSM-PPS v3 which was released in 1999, it is now out of service. The current software for optimizing, balancing, and generating programs for a Topaz and other Gem machines off-line, is GemLine-PPS v8.0,
Electronics Forum | Thu Nov 24 21:19:40 EST 2005 | smartasp
Hi, We are also a hig mix low volum plant situated in Sri Lanka and just installed 2 Opals inline from Assembleon with the feeder exchange carts for faster change over. This machines can be upgraded to Topaz by just installing 4 more heads. So far
Electronics Forum | Mon Nov 17 04:03:08 EST 2008 | griffin
If the whole board is shifted then it must be a problem with the clamping of the fixtrue to the machine or the board to the fixture, or the fiducial reading that is incorrect. Are the fixation of the board to the fixture the same in both programs? A
Electronics Forum | Sat Mar 25 16:57:30 EDT 2017 | zippi
Hi, Our Company write a new software to Convert p&p files to assembleon text or xml file. We use it with an Ellipse 2, topaz X and an OPAL XII. You can check all positions compare with Gerber, set database number and compare component size, set fidu
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Tue Mar 06 17:22:42 EST 2012 | acsscott
OK, did some more testing this afternoon. First, I moved the LED’s from feeder location #23 to Feeder location 30. This is three down from the other component(#33) it is picking, so it should be able to hit them both at the same time for two of the
Electronics Forum | Tue Mar 06 17:24:31 EST 2012 | acsscott
OK, did some more testing this afternoon. First, I moved the LED’s from feeder location #23 to Feeder location 30. This is three down from the other component(#33) it is picking, so it should be able to hit them both at the same time for two of the
Electronics Forum | Fri Jul 24 12:12:52 EDT 1998 | smd
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | We don't even bother
