Electronics Forum | Thu Oct 11 14:56:27 EDT 2007 | chef
Thank you- my point exactly and it starts in SMT- operators pulling the wrong paste from the fridge, touch up using the wrong solder wire, etc. My solution- GET THE LEAD OUT!!!!! I'm a CM- high mix, low to medium volumes. No steady all day every day
Electronics Forum | Wed Sep 12 09:47:29 EDT 2018 | junkeymonkey246
Hello everyone, I have 3 Contact Systems CS-400B's 2 of which need arepair and the last needs servicing and 2 CS-400E's which need repair. These machines have been sitting idle for years are are in need of repair. I was in touch with the manufact
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
| 1 |
.png)