Electronics Forum | Fri May 02 16:58:39 EDT 2003 | swagner
We have been building with flex circuits for nearly three years now, its an automotive product utilizing lead free paste, I will give you a few pointers. 1. Evaluate your supplier carefully, make sure you have some kind of stretch tolerance on the p
Electronics Forum | Sat May 10 12:58:33 EDT 2003 | stefwitt
I find 100 feeder slots of 16 mm width quite sufficient. If there are two feeder tables, each table is ~ 36� wide. Even slow machines can travel that distance in less then 1.5 seconds. If I further assume, that an optimized set up may save 30-40 % o
Electronics Forum | Tue Feb 10 20:40:49 EST 2004 | Kevin McCarten
1st thing to be said; I work for a company that supplies Desiccant Dry cabinets to the electronics industry for the storage of moisture sensitive components. The answer here really lies in inventory management/control. Ultimately you want to avoid b
Electronics Forum | Wed May 04 17:15:02 EDT 2005 | siverts
Hey Dr . Klein, I think You do it all right... But here it comes: MSD; what does it really means? MS-level; what does it really means? Floor life what does it really means? I'm sorry but I can't answer all these questions right now. It is a complex m
Electronics Forum | Mon May 12 18:45:57 EDT 2008 | locostpp
Hi All, We are embarking on the design of an ultra low-cost pick and place machine for use by small manufacturers & would appreciate some input. Here are some points: Low cost - in the region of $6-11k (higher cost versions faster) Two cameras (up
Electronics Forum | Thu Oct 18 15:03:48 EDT 2012 | rway
2) Start with the PLC. What do the indicator lights tell you. Is your entry sensor working? Your PLC has status lights that should go on/off with the input/output conveyors. Can you be more specific about "not operational?" This is a broad stat
Electronics Forum | Tue Jan 17 14:59:03 EST 2023 | symakhan
Hello Again A few days ago, I posted about Solar panels installation in my construction project. I got amazing response from everyone. I am grateful for all the advice and suggestions. I am also sharing all the details here in hope they will be help
Electronics Forum | Sat Feb 14 19:35:51 EST 1998 | C. Lao
Mr Lao We have some specialist knowledge on this subject and offer both equipment and services for these tests. My first recommendation is that take coupons manufactured by your PC Fabricator and then samples at each manufacturing stage: Bare coupon
Electronics Forum | Mon Jan 22 15:51:46 EST 2001 | aiscorp
TransCollaborative Manufacturing software (TCM) is involved in virtually all events flowing from receipt of CAD and BOM data, to procurement of components, to conversion into useful information, and finally to the production of actual product Consid
Electronics Forum | Thu Sep 30 03:17:45 EDT 1999 | Brian
| Hi everyone, | | Greetings! | | I�ve got a 2-layered through-hole PCB�s having the following problems: | | Solder Mask peels after wave soldering at random locations and only at the bootom side of the PCB | Insufficient Solder and some solder ne