9438 tri results

Electronics Forum: tri (Page 221 of 944)

Usb Type A Connector Help

Electronics Forum | Tue Jan 29 14:22:27 EST 2008 | operator

Yeah i don't know I have not seen the actual application. RTV was already discussed by the customer and they don't want it. That is what I was thinking too. It is poor design and they are trying to find a cheap way out that doesn't look cheap. Thanks

Stencil Design Question

Electronics Forum | Thu Feb 14 21:24:20 EST 2008 | daxman

Thanks for the ideas! We're gonna try em all, I'll let you know how it turns out.

PB FREE AMD 940 SOCKET

Electronics Forum | Thu Feb 14 07:33:24 EST 2008 | cyber_wolf

Does anyone have any experience with this component ? We seem to have some warping issues through reflow. We have tried everything profile wise....pre bake parts etc.

High Temp Chain Oil

Electronics Forum | Wed Feb 20 13:50:51 EST 2008 | jdengler

Try Castrol Industrial North America Inc. 150 West Warrenville Road; 605-3E Naperville IL 60563 USA Tel.: +1 877 641 1600 Fax.: +1 877 648 9801

Tented Via's

Electronics Forum | Thu Feb 21 14:54:36 EST 2008 | shrek

KRIKIES! tenting WILL inhibit solder flow through the top-side me lad. In the meantime, me chap, have you tried to adjust wave parameters? i've read threads here that a vibrating wave will tend to push solder up through holes.

Exhaust Fans

Electronics Forum | Fri Feb 22 08:13:02 EST 2008 | davef

Try: * Grainger [www.grainger.com] * Mc Master-Carr [www.mcmaster.com] Use a blast gate like McMaster-Carr 1822K315 located on each port of the machine. These will help balance the air flow entrance to exit as well.

Quad Qsv-1 Low House Air Pressure

Electronics Forum | Fri Feb 29 09:15:23 EST 2008 | jdengler

I do not know the QSV-1, but it sounds like there is a sensor that would detect when the clamp is open. Try to find this sensor and see if it is working.

help how to measure placement cpk

Electronics Forum | Fri Feb 29 09:51:39 EST 2008 | iantech

Guys I am trying to measure the placement repeatabilty of my placement machines, and I was wondering if you guys had any usefull excell tools you have developed along the way that might help me input the figures so my bosses can understand ian.