Electronics Forum | Wed Jun 02 11:19:18 EDT 2004 | black5629
I have a MPM3000, I have tried the multiple models still same problem. When you Teaching Board Stop Y, do you set the cross hair at the leading edge of the board?
Electronics Forum | Wed Jun 09 17:23:05 EDT 2004 | Claudine
Multi-national EMS in Manaus: Flextronics, Molex and Jabil. Also, Brazilian ones: Dolly, Flex and Tecplam. I don't have contact info handy but try the internet. Good Luck. Claudine cycorda@sono-tek.com
Electronics Forum | Sun Jun 06 11:01:36 EDT 2004 | adm
Hi I'm trying to plot a LSP profile to reduce void. But I do not have much info about LSP. Does anyone know what are the specific times and temperature of the LSP profile? And are there any ways to eliminate solder void other than changing profile
Electronics Forum | Sun Jun 06 11:02:33 EDT 2004 | adm
Hi I'm trying to plot a LSP profile to reduce void. But I do not have much info about LSP. Does anyone know what are the specific times and temperature of the LSP profile? And are there any ways to eliminate solder void other than changing profile
Electronics Forum | Wed Jun 09 14:32:02 EDT 2004 | davef
It's possible, but we'd be VERY surprised. [Never say 'never'] Fabs REALLY try to keep copper away fom the edges of boards, because it's a A-600 requirment.
Electronics Forum | Wed Jun 09 15:53:09 EDT 2004 | Ordie.
You might want to try Zestron. They make a lot of different cleaners. We use Zestron SD 300 if we clean a stencil by hand. It works great, a lot better than alcohol. Go to http://www.zestron.com. Hope this helps.
Electronics Forum | Tue Jun 15 03:24:56 EDT 2004 | Grant
Hi, Great, and thanks for the info, it's a big help to know someone's actually done it, and so we will give it a try on a few dozen product, and see what happens! Thanks again for the reply! Regards, Grant
Electronics Forum | Fri Jun 18 11:36:55 EDT 2004 | jdumont
Does anyone have any experience using AIM NC298, or any new NC solder paste from AIM in general. I have no experience with AIM and would like to give them a try. Thanks in advance JD
Electronics Forum | Sun Jul 04 19:32:16 EDT 2004 | indy
What is the most popular PCB finish for lead-free soldering ? We are using ENIG and trying out Paladium-Silver. Are tin whiskers an issue for anyone ? tin whiskering becomes a big issue if you have any military company as your client. They still p
Electronics Forum | Tue Jul 06 08:10:34 EDT 2004 | yukim
The manufacturer confirmed that it is humidity - the solder paste is too sensible to humidity. Now I tried Koki solder paste with good result. But, it does leave flux residue in good quantity. Does anyone have experience with Koki solder paste?