Electronics Forum | Thu Apr 14 14:16:51 EDT 2022 | dsmith
Hello and good morning. I've recently encountered an issue with a DEK tool and no one is able to remedy it. During the initializing phase, the table begins "bouncing" up and down and never stops, halting the process. There's a pass through proximit
Electronics Forum | Sun Apr 17 00:04:03 EDT 2022 | klauss
I am mounting 3535 Cree High-power leds with p&p machine. First nozzle picks up the led normally and then it's placed good but after 4-5 times nozzle picks up the led like at an angle. looks like it holds the led from the side edge of the dome.
Electronics Forum | Tue Jul 05 22:10:42 EDT 2022 | nellegaard
I am currently trying to setup a used MyData My19 machine and am currently having issues installing tools getting errors such as failed to pick up tool and Z force sensor failed. I have tried to clean the tool pickup area as well as clean and lubrica
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Thu Dec 29 14:09:45 EST 2022 | proceng1
Your best source of parts and info for MPM machines is PPM in New Hampshire. George, who is the oracle when it comes to these printers is no longer with the company, but either Ed Sullivan or Steve Brown can probably assist you. I had a UP1500 and
Electronics Forum | Thu Jan 19 18:11:45 EST 2023 | atpico
My UP2000 HiE Printer on Power-ON during initial Reset will show this error and reset will abort with no way to continue. E00938 10 - HARDWARE LIMIT WARNING In Input/Output Screen all Sensors are in normal situation and will react normally when t
Electronics Forum | Thu Feb 09 19:35:09 EST 2023 | youngbuck
Hello, We have a Dek Infinity when powering up will not initialize due to an error that says Rising Table Error (Position Error). I try to go to Diagnostics but it will not let me into anything. I press start when I'm in diagnostics and it just error
Electronics Forum | Fri Feb 24 18:25:09 EST 2023 | stephendo
The single most common problem I have seen is not always having ready to run error free kits for SMT waiting at all times. It eats into SMT production a lot more than most people think when there is even a single question about a part. At one OEM we