Electronics Forum | Mon Nov 29 20:15:22 EST 2021 | erici
Thanks for the message. Yeah the machine was about to start-up when the problem happens. I will try your suggestions. Thanks again.
Electronics Forum | Fri Jan 14 17:07:40 EST 2022 | cyber_wolf
We used to use a Dremel with a cutoff wheel. You can clean the cuts up with an X-acto.
Electronics Forum | Wed Jan 19 19:14:12 EST 2022 | charliedci
Looking for opinions on pic attached of ENIG finish. appears to be over-etched gold, but I am not trained up on PCB fabrication.
Electronics Forum | Fri Jan 21 06:35:51 EST 2022 | stivais
"Manual washing" of a misprint board basically is smearing of printed solder paste all over the board. And trying to remove (wipe off) it afterwards. So for me it would not be any surprise that the solder paste ended up on the pads where it was not i
Electronics Forum | Wed Feb 16 20:41:48 EST 2022 | mihai_voivod
Thank you guys for all of the feedback. I ended up swapping the left and right conveyor belts and they seem to have been working properly for 24 hours.
Electronics Forum | Tue Mar 01 03:17:40 EST 2022 | gary_sastrillas
Hi Guys, did anyone here selling the old siplace pro 7 up server with licenses Siplace Pro Server and Machine Connections License.
Electronics Forum | Thu Mar 03 03:54:38 EST 2022 | gary_sastrillas
The only way can detect, play around with your vision teaching with the component. and adjust the pin tolerance.
Electronics Forum | Thu Mar 17 18:20:17 EDT 2022 | SMTA-64387687
It sounds like a mechanical issue. Otherwise, you'd lose other calibration. Try backing up the parameters. Then, when the camera is out of calibration, restore the parameter and see if that fixes the problem.
Electronics Forum | Thu Mar 24 22:57:32 EDT 2022 | glasscake
Issue was solved by replacing servo motor/encoder wiring harnesses. Hooking a scope up to the head showed we were losing steps.
Electronics Forum | Wed Mar 30 18:00:27 EDT 2022 | compit
If you do not find it until Monday - write. I have one, but I won't be at work until Monday, maybe I'll help.