Electronics Forum | Wed Apr 18 15:10:35 EDT 2012 | smtivan
Dear Colleagues! Our organization has a lot of not-intellectual feeders for Essemtec Pick&Place CSM7000, but we would like to use this feeders in Essemtec CSM7100. Does it possible? What will we need to do for normal work of CSM7100 with old feeders
Electronics Forum | Thu May 03 15:07:59 EDT 2012 | rodrigo
Hi all, What the largest part I can place with these machines? I'm going to try to install a PLCC68 using the front light because the part is bigger than the backdisk and I want to make sure it can handle it. The part is about 30mmx30mm. Thanks
Electronics Forum | Wed May 16 09:23:04 EDT 2012 | jeremymek
In my experience Both Dek and speeline machines are good used. personally I think speedline seem to hold up better when PMs have been ignored though. Also make sure you can get a third party board support system into it like a gridlock or Vacunest
Electronics Forum | Tue Dec 18 10:14:14 EST 2012 | moshesh
In those cases where we have a 3.2mm thick, 16-layer board with several GND layers, do we still need ground connection to each and every layer (with thermal relief) or, skip part of the ground patterns? Will it help soldeing rising. I can't reach mor
Electronics Forum | Wed Dec 19 11:12:05 EST 2012 | aj
have you considered intrusive reflow? I ran a product similar to what you are describing and the only way we could get sufficient holefill consistently was by this process.... there may be obvious reasons why you cant but worth a shot if you can- it
Electronics Forum | Mon May 21 09:04:15 EDT 2012 | cbeneat
We've had the same issue on our Panasonic CM machines with Cree XP type LEDs. Count on tools makes a urethane tip nozzle that we are using which eliminates the sticking, our concern with these is durability. Nozzle supply company makes a steel Teflo
Electronics Forum | Wed May 23 14:13:50 EDT 2012 | adetuc65
Hi aj thanks for the reply. you are right we rarely use 130kV it would be a great if you could send onto me what have researched that would be amazing. my address is adrian.tucker@emc.com thanks again Ade
Electronics Forum | Tue May 22 11:38:04 EDT 2012 | naynayno
I am looking for IPC or other published standards that specify cleanliness levels for: 1) solder paste stencils 2) selective solder pallets When we cleaned PCB's we used a limit of 4 M-ohms. Now that we have transitioned to No-Clean, I am wonderi
Electronics Forum | Wed Jun 06 20:49:36 EDT 2012 | edri_mun
we encounter the same problem as you 3 years ago. but now we have implement to use KIC 24/7. you just need to take 1 time profile (for the base line profile), and then for the next time you run your product, it will take profile for each board you b
Electronics Forum | Fri Jun 08 16:36:58 EDT 2012 | noid
KIC 24/7 has evolved into RPI. Not only will it give you virtual profiles, it also gives you DPMO and yield, based where each board lands in the process window. The good thing about this software, you can go back a year later and look up a specific
