Electronics Forum | Sat Nov 07 22:00:29 EST 2015 | ttheis
I've seen a few used machinery companies using manual smema interface boxes with a few buttons on them to simulate upline and downline equipment but I haven't found anyone selling them or info on them. Does anyone know where they can be bought or if
Electronics Forum | Mon Apr 11 00:34:39 EDT 2016 | smtsparescn
Both CL feeder and FT/FS2 feeder are mechanical and driven by air cylinder,and they have similar structure, CL feeder is paired up with YV series,FT/FS2 is paired up with YG series,but actually FT/fs2 feeder can be used where the cl feeder is used,t
Electronics Forum | Thu Feb 25 14:52:52 EST 2016 | tombstonesmt
How thick are their requirements? A barrier can be made using peelable latex. That would then require manual or automatic dispense of latex to create a dam. Then you should be able to use an automated dispense system with a large orifice and flood
Electronics Forum | Wed Nov 30 03:42:42 EST 2016 | bukas
i have a SPA 250, it has serial connector but uses RS485. only 2 pins of serial connector are in use. it is very likely that this is the case with SPA 400. there are some settings in offline editor, if you havent fixed it yet i can send you some pict
Electronics Forum | Tue Apr 19 07:23:39 EDT 2016 | clockwatcher
For ESD control in the factory we use foot & wrist straps, and ESD smocks. We also have ESD work surfaces including ESD flooring throughout the plant. We have been using ESD chairs and now the question has come up on if and how often these chairs nee
Electronics Forum | Fri Apr 29 08:28:12 EDT 2016 | sumote
Radio Shack used to sell etching solution in a pint bottle. There may be a hobby shop that does as well. Pay attention to the Handling/PPE/Disposal requirements!!! Not to take you away from your venture, but there are some companies that specialize
Electronics Forum | Fri Jun 03 09:37:59 EDT 2016 | sumote
Same here. Buy it by the 2-pack at Staples. If the tape does not get used often we pull off about 5 inches and discard before we use it. The exposed tape between the cutter and the roll, and 1 rotation around the outside of the roll attracts dust and
Electronics Forum | Thu May 12 10:49:27 EDT 2016 | Bill Albright
If an electronic component with a MSL rating of 1 is exposed to an moist environment greater than the 85% relative humidity to the point where the packaging is wet, what is the risk level of using the device in a lead-free soldering reflow process?
Electronics Forum | Fri Jun 03 09:15:47 EDT 2016 | designhaus
I had this long post typed up and then I re-read > your post. No used equipment? Like others have ... I wish you had posted your reply. Any feedback is welcome. As I said, we can pour more money into this if we can justify it. 85K grant is nice, b
Electronics Forum | Mon Jun 20 14:01:37 EDT 2016 | babe7362000
Does anyone know of anyone that would inspect our Finished PCBs using photos for their software, instead of shipping out the PCB's? We have boards that are quite heavy. We need them inspected for thru hole accuracy. Or if you know any software th