Electronics Forum | Wed May 10 00:46:32 EDT 2006 | Chris
I agree! I am using a SAC305 no clean from Alpha. I have noticed that even hand probing with volt meter leads requires me to press very hard on the pads to bust through the flux residue.
Electronics Forum | Thu Jun 01 20:58:25 EDT 2006 | ec
Hi Jack, The throw out is it after vision or before vision. Do u have any msn account.....using msn is much easy to discuss the issue with you.
Electronics Forum | Fri Feb 09 03:14:19 EST 2007 | Pana user
Have you tried using PanaPro software to do optimization? Pick and Throw? Try adjusting the recog lighting..
Electronics Forum | Thu Jun 22 00:16:24 EDT 2006 | Gman
Hello, Has anyone had issues with voiding while using Imm Silver PCB finish. Does thickness of silver, contamination of the plating bath or other factors if you come point out cause voids due to the plating.
Electronics Forum | Fri Jan 25 05:22:47 EST 2008 | dekiper
Hi, You could try other types without brass shim. It's also important to use a good tool that is adjusted properly. Contact me and I will help you with quality samples and instructions. http://www.dekitools.com // Per Gester
Electronics Forum | Fri Feb 16 07:55:37 EST 2007 | ronsou
Anyone have any experiance with these Juki machines? I have no experiance with Juki except for a Zevatech place-mat 360 many years ago. Currently using Siemens and Mydata. How is the accuracy, speed, durability, and programming. Any help would be a
Electronics Forum | Tue Jun 05 16:39:37 EDT 2007 | larryp
We are looking at ESD chairs in our EPROM room. Currently we are using smocks with wrist straps, this was set up before me. Is there any special or different things that needs to be done to the smocks to make them work with an ESD chair?
Electronics Forum | Thu Nov 15 12:11:40 EST 2007 | George
I use Pentagon EMS (503) 924-2747 with Chad Haima. Note: I do not get a penny for referals. I just like the service, super fast, high quality and excellent customer service. I have worked with them for about 4 years. Thanks, George
Electronics Forum | Tue Feb 19 05:00:07 EST 2008 | muarty
We have used both Datapaq and ECD Mole in the past. Either system will do the job for you, slight preference would be for the ECD system.
Electronics Forum | Thu Mar 13 09:43:13 EDT 2008 | jseagle
If the mask is not cured and is coming off in the pot I don't see how it is protecting anything. If you want to mask something fast you need to use tape not liquid mask that requires cure. My $.02.
World Equipment Source has over 20 years experience in Electronic Assembly Equipment. We will resell your equipment by utilizing our global market of associates.
Equipment Dealer / Broker / Auctions
8655 Production Ave Suite B
San Diego, CA USA
Phone: 858-693-1991
