Electronics Forum | Tue Jun 25 22:22:22 EDT 2019 | proy
We have an electrovert 16" econopak wave solder machine with two identical pots (exchange between Tin Lead and Lead Free). When the pots are exchanged the same thermocouple is used, and the same controller is used - with the set point adjusted. The S
Electronics Forum | Mon Jul 01 14:46:47 EDT 2019 | assuredtech
It's been awhile but yes, if you do not allow the machine to optimize your program and your placing sequence is such that the tallest component is perhaps the 1st or last placement so it doesn't bump into other components, next is you may look into a
Electronics Forum | Mon Mar 01 21:14:26 EST 2021 | davem
Hey Guys, so I have 3 Vitronics wave solder machines to care for (2 x 6622 and a Delta 5) and they're in need of some TLC. One thing they look to be badly in need of is some conveyor chain work. I found a thread here on chain cleaning, but wanted to
Electronics Forum | Mon Mar 13 19:25:12 EDT 2023 | griinder
Barcode Definition - you can input the search window size. Default lighting works best for me. I name it "bc". Window>Barcode List- This is where you input the position on the panel or circuit 1, give it a ref designator "again I use bc", and select
Electronics Forum | Fri Jul 24 12:12:52 EDT 1998 | smd
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | We don't even bother
Electronics Forum | Mon Jan 08 10:49:35 EST 2001 | Simon
We are using the omega meters to determine the solvent extract conductivity. The book is refering to standard MIL-P-28809 who specifies a 14 ug/sq. in. of Na/Cl limit. The past owner of our machine was setting the pass/fail limit at 3.6 ug / sq. in.
Electronics Forum | Wed Sep 20 17:06:23 EDT 2000 | jackofalltrades
On the Vitronics/Soltec Wave Soldering Machines, we have no problems with the hot air knife (called a "Select X De-Bridging Tool" by Vitronics). We have both Delta's and Delta Max's. We have used both air and nitrogen with no problems. When using a "
Electronics Forum | Thu Sep 21 12:03:35 EDT 2000 | Boca
We have been using a hot air knife on Electrovert equipment for a few years. It must be set up properly for a given machine, primarily the distance from the trailing edge of the wave. Sometimes the set up must be adjusted for the assembly being sol
Electronics Forum | Thu Jul 20 18:19:53 EDT 2000 | Darby
If you are using embossed tape you can use super glue and put the last pocket of the old tape into the first pocket of the new tape, or visa versa if that suits your feeders better. You can also simply glue old peelback onto new leader, wipe away all
Electronics Forum | Tue Mar 20 15:59:27 EST 2001 | CAL
I only inhale flux with a high IPA content.(joke for those who don't know me) I have seen the inside of duct work for our wave soldering machine............NASTY! DAVE F. is right! Flux contains a lot of bad stuff- Chlorides, Bromides, Fluorides,