Electronics Forum | Thu Aug 03 19:34:17 EDT 2006 | davef
You might consider an oxygen monitor (or lack of oxygen monitor). A fast response-rate analyzer should be used. There are several types of analyzers on the market and each has different limitations. * If you are looking for a measurement ranging fr
Electronics Forum | Fri Sep 08 20:32:24 EDT 2006 | mika
Hi, I can understand why a lot of people are concerned about this deal. I have some little experience of this. I used to work for an electronic manufactory company 5.000+ employee (divided on several sites) and it was sucked up by an investor Corp. W
Electronics Forum | Tue Sep 12 16:27:20 EDT 2006 | EK
I'm in the market, also, but vasilating over cost vs performance. I've also used both. In general, the LPKFs have more bells and wistles. On the LPKF S62, I love the tool magazine, and vacuum table. And, the fiducial recognition camera is great o
Electronics Forum | Wed Sep 13 10:31:14 EDT 2006 | CL
Hello Brad, We are running the Slim Kic 2000. We have found the predictions to be fairly accurate as long as the suggested change is within 20 degrees of the original recipie. As a test I ran a board with the wrong profile. The predictions got me wi
Electronics Forum | Thu Sep 28 07:57:58 EDT 2006 | cpm
Hi, Expert, Currently, I'm facing a very critical problem on my HAL leadfree finishing PCBs at my customer end. We run the HAL leadfree (Tin, cu and ni) board by using HAL leadfree machine (temperature about 270 deg.C) and go for normal water post c
Electronics Forum | Tue Oct 03 17:04:07 EDT 2006 | cuculi54986@yahoo.com
Glenn, What alloy are you using for Pb-free HASL? You say tin copper nickel, but is it SN100C? Against manufacturing engineering's recommendation, my company specified simply "Pb-free HASL" as the finish for our Pb-free PCBs. One of our suppliers
Electronics Forum | Tue Oct 17 17:17:17 EDT 2006 | rgduval
I'm in the middle of developing an ESD program at my company, trying to adhere to S20.20 as much as possible (and the suggestions of the ESD audit conducted before I got here). I've been discussing the pros/cons of pink-poly foams and black foams.
Electronics Forum | Thu Oct 19 16:12:59 EDT 2006 | sliebl
Our machines can't use 'cad data' for fids. I'm intimately familiar with these machines as I've been using them for 11 years. Most likely, it's a limitation of our machines/software, whereby it requires symetrical local fids. When we place a PCB on t
Electronics Forum | Wed Dec 06 11:16:06 EST 2006 | Todd
Ok, an update... I finally found my 24Vdc. I was trying to use a screw and/or outside of the connector for ground. It was necessary to use the ground IN the connector pins. I believe it was the top/right and 3 o'clock pins that toggled with the 24Vdc
Electronics Forum | Thu Dec 07 19:54:55 EST 2006 | davef
We agree with "guest" above. This a "chip bonder" type material used to improve the reliability of array type devices. "A relative comparison of the N50 values is given below: No underfill = 1.0X (baseline) Corner bond = 1.3X Non reworkable underfi
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491